HELP!!! HIDs burning my hosing and my driver side light isn't even
A week or two ago I was behind a car and I saw the cut off for my passenger light but it was like I didn't even have light on my driver side. I got out, check the bulb to find that my bulb on the driver side was halfway out . I put it back in and when on with my route. Got home and pulled into my driveway and notice the same thing happen to my light and I put it back in AGAIN . So I had about enoght if that crap and really started to work on it and notice that I had to put the relay down below the bulb just to add weight to it so it won't twist and pop out again. Tonight I notice that the bulbs was not level and notice that there was much more glare on the left side (the problem side) then the right side. I looked in the hosing and notice that the top part of the housing is burnt on the left side and a little burnt on the right side on the top part. I thought that HIDs ran cooler than OEM lights so I don't know why this is happening. I also swapped out the light with the light on my other side and I"m still having the same problem. I put the OEM light back into the housing were I'm having the problem and it fits like a glove so why would one side fit my HID bulb like the way it should fit but my other side is making it loose but yet, its fine when I put the OEM bulb in it.
__________________ -Marcus- 2012 Ford Escape XLT 3.0L V6 AWD White Suede Current mods: 6000K HID low/hi beams; Passport 9500ix; Garmin NUVI50 5% Tint; Tinted Tails; Duel Exhaust; Debadge Future mods: Lowing kit; Engine Tune; Black wheels; Monotone Paint Job