When my sunroof is closed the rear of the glass does not flush with the body. sits below approx. an 1/8" gap between the glass and the sheetmetal.
Any suggestions??
Thanks in advance
Vehicle: 2006 (DR) Ram Truck, 2005 - 2006 (LX) 300/Charger/Magnum,
2005 - 2006 (WK) Grand Cherokee, 2006 (XK) Commander
Concern: The rear of the sunroof glass is not flush with the roof of the vehicle.
Possible windnoise or water leak.
Cause: Out of calibration
Resolution: First, UNCALIBRATE THE SUNROOF. Place the ignition switch in RUN position.
Locate the sunroof fuse (Fuse 44 in the Power Distribution Center located in the trunk).
While the sunroof is still in motion, have an assistant remove the sunroof fuse. Reinstall the sunroof fuse.
Now, RECALIBRATE THE SUNROOF. Press and hold the sunroof vent switch until it stops at the full vent
position. Verify sunroof operation by opening, closing, and venting the sunroof.
Details: If the above procedure is sucessful, have dealer reprogram/update the sunroof control module
with new software.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Jeep Garage - Jeep Forum
1.7M posts
176.1K members
Since 2009
Jeep Garage is where you can talk about all your favorite jeeps including the Cherokee, Liberty and Grand Cherokee.