Re: 2015 GC Altitude Black grill rings....Will they fit my 2014 SRT?
Originally Posted by s4morris
Thank you, just ordered myself one!
How does the black backing plate come off to remove the factory emblem? Looks like there are two pieces that secure into the liftgate?
I am passing along info from 5.7summit - as I had the same question.
The entire Jeep emblem is one piece - so you have to 'peel' off the chrome emblem just like the rest of the emblems. As it is recessed I used a combo of goo-off and WD-40 to loosing the glue - followed by hairdryer and an older credit card to work the double sided tape. BE CAREFUL not to scratch the paint and clean up the excess solvent that runs down (I keep a bucket of soapy water to clean it off quickly. Took me about 10 minutes of prying/solvent and heat to get it off - along with a small plastic pry bar - the whole thing pops off.
Then you have to work all that old doublestick tape off and that take patience - but once cleaned off - you are good to re-apply the new one
I love the lack of the big chrome piece on the rear - my wife says it looks too secret - but I think the black on black is perfect
*see what did you do to your WK2* string for pics
"Dark Shadow"- 2014 Jeep GC SRT
BT Catch Can, InJen CAI, Tint all around, debadged, Tinted tail lights, Vinyl Wrapped Window Trim, Road Magnet-Mids, Blackops endlinks & rear control arms, Black Powdercoated Borla ATAK, 87mm TB, CFR front splitter, Cross Drilled Brembo Sport Brakes w/Hawk Pads, Black coated Spider Monkey Rims, Blendmount Valentine V1