Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Troubleshooting/Problems (
-   -   Control arm bushings (

Frango100 01-25-2011 09:11 PM

Control arm bushings
I have to change the front upper control arm bushings in the axle lugs and i saw brands like Crown and Omix Ada (Quadratec). On an other site they where complaining about the quality of the Crown bushings, seems that they wear very quickly. (they are also quite cheap, around 10 USD.)
Anybody overhere good or bad experiences with any brand bushings?

Frango100 01-27-2011 09:12 AM

Re: Control arm bushings
Am i the only one with worn control arm bushings:confused:

DJ BoNiOmArIo 01-27-2011 11:54 AM

Re: Control arm bushings
me too on my wk

Sskafar 04-06-2011 05:45 PM

Re: Control arm bushings
How did you know they were bad? Did you hear alot of clunking in the front end? I have 91,000 on my WJ and I and trying to locate the source of a front end clunk going over rough roads and bumps.

Frango100 04-06-2011 06:43 PM

Re: Control arm bushings
No, there was no clunking at all. I just discovered it when i was changing the diff fluid. The rubber was just worn away and the center metal tube which normally is suspended by the rubber (and where the mounting bolt goes through) was completely loose. This was only at the upper right hand control arm bushing which is mounted in the front axle lug. All the others are ok.

emtclark 04-11-2011 10:32 PM

Re: Control arm bushings
Don't know but have you done a search on "worn control arm bushings"? I too would be interested in what is recommended most. Energy Suspension? They are great with things like sway bar bushings-would think they be great with this too...

All times are GMT -5. The time now is 08:23 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community