ABS Brake module/ABS lamp on
Anyone who gets a ABS brake lamp coming on and gets a scan code indicating the ABS electronic module is faulty might save themselves a lot of money by removing it themselves rather than accepting any (expensive) quotes at face value. I was quoted $AU2995 for a new unit and installation. After researching it a bit I discovered that by undoing the four 4mm torx screws and unplugging the unit I only had to send it away for a $350 revamp, reinstall it and Voila' all working again with a "saving" of $AU2650 ! ! So DON'T get ripped off, do your research using multiple sources and sus things out as there is always a better, cheaper way. :D
Location: Tasmania, Australia
Jeep Then: ZJ I6 4 L Stock
Jeep Now: WJ V8 4.7L "Vision Limited"
Re: ABS Brake module/ABS lamp on
do u know if there is a way u can bypass the abs module and abs pump ??
|All times are GMT -5. The time now is 12:39 PM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community