Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Technical Tips/DIY/How-To (http://www.jeepgarage.org/f187/)
-   -   How To: Install a mesh grill on a 08 WK (http://www.jeepgarage.org/f187/how-to-install-a-mesh-grill-on-a-08-wk-2228.html)

08Hemi 08-24-2009 12:36 AM

How To: Install a mesh grill on a 08 WK
 
So I went to Home Depot today and had to make myself a grill:D! I will show you what I did and feel free to comment or ask anything...

I bought:

Rustoleum Gloss Black Spray paint
Rustoleum Lacquer (clear)
16 3/8 in #6 or #8 head screws
16 #8 or #10 head washers
1 Aluminum sheet (cross-hatched)

Tools:

Flat head screw driver
Phillips head screw driver
Power drill with small taping bit (half of screw)
Plastic Cutters
Wire/sheet metal cutters
Metal file for rough edges


1. First take off the grill. There are 6 push clips that are holding the grill in. Use the FH screwdriver to pop these off. Very simple

2. Put the grill face down on a towel or something soft. Cut out all plastic pieces and tabs. You want the grill to sit as flush with the back as possible, so trim the tabs well.

3. Cut a piece out of aluminum foil that is the entire size of the back of the grill. I error'd on the side of larger to ensure I could trim as needed. This really helped later so I recommend doing this. I painted it gloss black; it looks great and is subtle so I am happy with the chrome-gloss black contrast!

4. Test fit the aluminum. I cut around the four tabs on the bottom of the plastic and the center of the plastic piece, also around the edges and any area raising the aluminum up. I also cut slats in the aluminum for the 4 chrome plastic tabs that stick out. I did not want to cut those off so you can do whatever you want here.

5. Make sure the grill is set and fits properly all the way around. Take your time; I spent over 15 mins trimming the aluminum around the back of the grill!

6. Pre-drill your 16 mounting locations on the top and bottom of the grill. Make sure it is where you want it. I chose 16 screws but you could probably get away with less. I did mine in the same general locations on the top and bottom so it looks really clean and holds the grill firmly in place.

7. Put the washer in-between the aluminium and the screw, tighten them down starting from the middle and working outward. Tighten hand-tight ( I used a drill but it does not need much force)...the aluminum will set with the washer.

8. Fit the grill back onto the car and insert the 6 push pins starting with the center and working outwards.

9. Drive around for 10-20 miles or so. Take the grill back off and tighten all of the screws. All of mine needed a little tighten as I think the grill settled in a little bit. Needless to say it is very tight on there and is actually one with the stock chrome grill (for all intents and purposes it is one piece :) )! Now put it back on and the 6 push pins back in....

You are all done...you now have a grill!


http://i645.photobucket.com/albums/u...2/DSC00915.jpg

http://i645.photobucket.com/albums/u...2/DSC00923.jpg

http://i645.photobucket.com/albums/u...2/DSC00925.jpg


http://i645.photobucket.com/albums/u...2/DSC00939.jpg

http://i645.photobucket.com/albums/u...2/DSC00965.jpg

http://i645.photobucket.com/albums/u...2/DSC00963.jpg

http://i645.photobucket.com/albums/u...2/DSC00956.jpg

So what do you think? Not bad for about $20 in products and about 2 hours total including paint drying and test fitting...:thumbsup:

Chaoul1 08-24-2009 12:41 AM

Re: How to: Mesh grill on a 08 WK
 
Nice job kinda hard to tell in the pic. Your right it's not bad I think it looks good. Paint the grille white now!

08Hemi 08-24-2009 12:45 AM

Re: How to: Mesh grill on a 08 WK
 
Thank you...yeah I have always wanted to paint the side chrome moldings and my grill white. I need to save up for that!!! Here is another finished pic...I will take more tomorrow in the daylight. I finished in the dark haha


and here is a before pic...

http://i645.photobucket.com/albums/u...2/DSC00737.jpg

After
http://i645.photobucket.com/albums/u...2/DSC00955.jpg

More after pics in the daylight...



http://i645.photobucket.com/albums/u...2/DSC00962.jpg

http://i645.photobucket.com/albums/u...2/DSC00966.jpg

http://i645.photobucket.com/albums/u...2/DSC00958.jpg

White WK Swagga 08-24-2009 06:07 AM

Re: How to: Mesh grill on a 08 WK
 
Nice job Brad. You just inspired me to do something like that too. LOL :thumbsup:

DAVY27 08-24-2009 06:17 AM

Re: How to: Mesh grill on a 08 WK
 
self made stuff's the best! looks good brad. prolly do something like that also

Scottina06 08-24-2009 06:32 AM

Re: How to: Mesh grill on a 08 WK
 
good job

jeepnjeep 08-24-2009 06:37 AM

Re: How to: Mesh grill on a 08 WK
 
Looks good. I shoulda taken pics when I did mine.

Megatron 08-24-2009 07:38 AM

Re: How to: Mesh grill on a 08 WK
 
coolio. who wants a 07 black grill. ill have one soon, nate?

Frankie 08-24-2009 07:42 AM

Re: How to: Mesh grill on a 08 WK
 
Great Job man!!!!! +rep

White WK Swagga 08-24-2009 07:49 AM

Re: How to: Mesh grill on a 08 WK
 
Quote:

Originally Posted by EZY (Post 51094)
coolio. who wants a 07 black grill. ill have one soon, nate?

What chu talkin bout??? Lets do it shorty. Does anyone have a white grill? Only white WK's Ive seen are limited's.

Megatron 08-24-2009 08:14 AM

Re: How to: Mesh grill on a 08 WK
 
Quote:

Originally Posted by White WK Swagga (Post 51098)
What chu talkin bout??? Lets do it shorty. Does anyone have a white grill? Only white WK's Ive seen are limited's.

Joe got mine at the moment. Wait nvm. You have an 08.

White Chocolate 08-24-2009 09:04 AM

Re: How to: Mesh grill on a 08 WK
 
Very nice mod, I'm going to do this, very cheap to do :)


All times are GMT -5. The time now is 03:11 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community