Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Engine Performance/Intake/Exhaust (
-   -   Installed! Dual Aeroforce Interceptor Gauges (

Crestwood1001 09-13-2011 09:56 PM

Installed! Dual Aeroforce Interceptor Gauges
After seeing Rob's dual aeroforce gauges in the sun glass holder pod, I wanted it, but they were way outta my price range at the time. Iv been looking for an OBD2 scanner for a while now, and just happened to come upon one of our members selling what I wanted! Dual interceptors and the sunglass pod. BOUGHT!
They came in today, got right to work, the install was pretty strait forward, the hardest part was getting the pod in since I had no instructions, I pulled down the overhead console...

Once it was down I had to look over the console to figure out what to do next cause of the lack of directions, I started off by pulling off the swing down door that holds the glasses. Then I looked at the top and saw 4 plastic rivets that seemed to be holding on the "roof" of the sunglass holder. I popped the rivets off and guess what!? I had the access I needed!
So next up on the list was getting screws that would work, since again, all I had was the pod, no hardware or instructions, I took the pod up to the local hardware store and got two different types of screws to make sure at least one would work. Grand total? 35 cents!

Got back and test fitted the pod, perfect, leveled it out and held it up to the ceiling a few times and all was well, so I screwed it into the overhead console and got to mounting the two gauges. Again, easy as hell, each has a metal bracket that fits over two studs on the gauge itself, then two thumb nuts and they are in!

I made a small hole in the black plastic housing that the console fits in to run the wires, then used a clothes hanger to fish the wires from the gap at the top of the windshield into the opening for the console. Hooked up the gauges and remounted the console. Then simply ran the wire down the a pillar and into the OBD2 port. DONE! Spent the next hour playing the the parameters for what I wanted displayed, still messing with that, but right now the first pod shows RPM on top and Horse Power on bottom. The second pod shows Coolant Temp and Tranny Temp. I also programmed the red LED's on each gauge, the first pod lights up at 2,500 RPM, the second gauge at 3,500 RPM. So when im using the auto stick iv got a silent reminder of where im at.
Must say I LOVE these things, and the mounting location is awesome, not some super flashy A pillar pod, but still looks great and is easy to see. FINISHED PICS!
IMG-20110913-00238 by WTVFD1001
IMG-20110913-00239 by WTVFD1001
IMG-20110913-00237 by WTVFD1001
(Note: In this pic its showing RPM and HP on the first gauge, and INTAKE AIR TEMP and COOLANT TEMP on the second)

So at the end of the day iv got my OBD2 scanner, and then some, these things can even let you change the diameter of your tires to correct the speedo, turn ESP completely off, change the idle RPM's, and even look at and clear DTC codes. Im gonna make you guys a video asap once I can get a quality one. They are awesome, im in the love, the end :thumbsup:

robpp 09-13-2011 10:11 PM

Re: Installed! Dual Aeroforce Interceptor Gauges
nice bro. looks good.

im surprised more dont do this mod/

Crestwood1001 09-13-2011 10:12 PM

Re: Installed! Dual Aeroforce Interceptor Gauges
They are kinda pricey strait up, but I got a dam good deal on them so I went for it!

JeepCoop 09-13-2011 10:27 PM

Good work maing!!!

SoCalMoparWK 09-13-2011 10:32 PM

Re: Installed! Dual Aeroforce Interceptor Gauges
I was offered a set, but I'm to in love with the 3 Gauged A-Pillar design...Looks sick though bro congrats.

SvenskaJeepGuy 09-13-2011 10:45 PM

Re: Installed! Dual Aeroforce Interceptor Gauges

StoneCold 09-13-2011 10:51 PM

Re: Installed! Dual Aeroforce Interceptor Gauges
Damn they are sick!!! I have a couple of gauges on the a pillar that I've still to wire up.

Nice work!

Crestwood1001 09-13-2011 10:54 PM

Thanks guys, iv always wanted some gauges, but in a 4.7 it would be kinda silly to have an A pillar full of gauges. I think these are a nice compromise, let's me see and do lots of stuff, but is tucked up high and is not flashy

Sent from my BlackBerry 9650 using Tapatalk

ekaz 09-13-2011 10:58 PM

Re: Installed! Dual Aeroforce Interceptor Gauges
I had those gauges in my jeep before my current setup, very nice gauges for sure.

Crestwood1001 09-14-2011 07:03 AM

They are dam cool!

Sent from my BlackBerry 9650 using Tapatalk

DaBigBone 09-14-2011 08:30 AM

Re: Installed! Dual Aeroforce Interceptor Gauges
Looks good!

SRTILL8 09-14-2011 08:44 AM

Re: Installed! Dual Aeroforce Interceptor Gauges
RIGHT ON!!! it looks great crest!

i got these too, not the same color but im slacking though.

All times are GMT -5. The time now is 06:29 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community