I am trying to figure out this whole LED thing. I am making up some switches which will connect to my amp and then LED's in back and fans, 3 switches total. I bought some 2 connector switched which i was going to hook up to a 470 ohm resistor to a 3mm LED that should cut the power down enough not to blow the LED but what about everything after that if i am trying to power a 12vdc fan with the LED in series with it. can anyone help me with this i really need to brush up on my basic electronics.
Re: LED Help
|All times are GMT -5. The time now is 08:11 AM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community