Jeep Garage  - Jeep Forum banner

steering audio controls

2K views 4 replies 4 participants last post by  harricanfloyd 
#1 ·
i am trying to find the wires for the steering control and speed sensor for my install of 7in tounch screen. i am using the axxess aswc. but cant find the wires in the car . have any one done this already
i have pinoeer head unit new speakrs and amps not using the bus
 
#2 ·
I used the PAC Audio adapter for my steering wheel controls and didn't have to find any wires, just had to plug them in.
 
#5 · (Edited)
to get the steering controls ready on my 05, I used the axxess. hooked up power and ground ofcourse, the tapped the pink wire and the blue wire with pink stripe... These wires were on the AXXES interface harness that was plugged into the radio harness. I didnt want to cut any wires on the factory harness. hope this helps
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top