Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Troubleshooting/Problems Discussion (
-   -   Loose Go Rhino Step Hitch issues (

Wxchaser 01-18-2012 06:46 PM

Loose Go Rhino Step Hitch issues
Can anyone tell me how they got a tight fit on their step hitch? It would be greatly appreciated. Install instructions are at link below:

After I noticed it was loose in the middle position, I moved it closest to the rear bumper, but still loose. Then to top it off, my universal hitch lock would not re-open! Had to get a jeweler's screwdriver to get the lock plate to open so I could slip the key in.

I think it may have something to do with the anti-rattle strap, anti-rattle clamp knob. Where it is loose is inside the actual 2 inch hitch receiver, that is where I find the slippage.

I have about the same thread posted in the WK2 forums but thought I'd post here too if anyone has suggestions, thanks.

wildturkey47 05-08-2012 04:46 PM

Re: Loose Go Rhino Step Hitch issues
I got aanti rattle hitch PIN and put in mine.:thumbsup:

All times are GMT -5. The time now is 04:36 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community