Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Troubleshooting/Problems (
-   -   Window switch (

rosado057 02-04-2012 06:30 PM

Window switch
2006 JGC 4.7 every time I use the the auto up for the window it closes then come back down again. I purchased a new master window switch from the dealer but it still happens. has anyone had this problem?

lll2for3lll 02-04-2012 06:56 PM

Re: Window switch
If you don't mind my 2, it sounds like it needs to be recalibrated.

lll2for3lll 02-04-2012 06:58 PM

Re: Window switch
Resolution: Calibrate the windows with the following procedure: Sit in driver seat and close door. Start engine. Use the switch to run the window down and hold switch all the way down for about (8) seconds. Run the window up and hold switch all the way up for about (8) seconds. Test window for correct express-up operation. Repeat procedure for other window.

lll2for3lll 02-04-2012 07:00 PM

Re: Window switch
^^^^Got that from marka2k over at JU.

DAVY27 02-04-2012 07:04 PM

Re: Window switch
try resetting it w/ what 2for3 said. or you can try this..start engine. hold down for 5 secs and hold up for 5 secs.

rosado057 02-04-2012 08:43 PM

I'll try it thanks

2005JGC 02-06-2012 01:52 AM

Re: Window switch
That likely wont fix it, this is a module issue, its sensing an obstruction and reversing the direction, let me look for the tsb but I believe at least at one point (maybe there is a revised one) the repair was replacing both window regulators and door modules.

Edit: my memory did serve me correctly...


NUMBER: 23-001-08 REV. A
DATE: February 26, 2008

This bulletin involves replacing both of the front window regulators and both front door
modules, if the modules can not be reprogrammed to the proper level.
2006-2008 (WH) Grand Cherokee (International Markets)
2006-2008 (WK) Grand Cherokee
2006-2008 (XH) Commander (International Markets)
2006-2008 (XK) Commander
NOTE: This bulletin applies to WK/XK vehicles built before October 4 th, 2007
(MDH1004XX) and WH/XH vehicles built before October 18th 2007 (MDH
The customer may experience a front door glass reversal, goes up and then comes back
down after the express-up function is initiated. This condition is caused by a combination
of a regulator motor issue and the sensitivity of the auto up software contained in the door

If the vehicle operator experiences the condition above on any front door perform the
Repair Procedure on both front doors.

rosado057 02-06-2012 09:03 AM

Memory didn't work.

All times are GMT -5. The time now is 09:19 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community