Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Interior/Exterior/Visual/Lighting (
-   -   Front Bumper removal - advice needed (

montgb 07-11-2012 02:30 PM

Front Bumper removal - advice needed
I'm installing the Altitude Front Grill and Rear Brow today, but I'm already stuck on step 1 - removing the front bumper. From searching the forum, it seems to be as easy as popping out the two plastic rivets in each wheel well and then yanking the bumper. However, getting those plastic rivets off is a pain, and I want to make sure I'm not missing a step.

The one that I was able to remove is stretched and twisted - no way that it's getting used again. Is there a more elegant solution than pulling on it with a plier?

Thanks, and I'll post pics once the new grill is on. :thumbsup:

Scottina06 07-11-2012 03:27 PM

Re: Front Bumper removal - advice needed
those are NOT reusable. Just cut them off. You will need new plastic rivets and a plastic rivet setter. There are also two bolts to remove

montgb 07-11-2012 03:46 PM

Re: Front Bumper removal - advice needed
Thanks Scott!

I also found the following thread:

All times are GMT -5. The time now is 06:08 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community