Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Wheels/Tires/Brakes (
-   -   General Grabber AT2 Tire Pressure (

Dcocch 08-20-2012 01:03 PM

General Grabber AT2 Tire Pressure
Put some AT2s on my WJ the other day. I put them at the 33psi recommended on the door but they look low to me. According to the General Tire website it says for 225/75R16 it's max pressure is 51psi.

Anyone else running higher than 33psi in their AT2s? I'm thinking I'll probably go up to between 36-40 and see if they 'straighten' out. Just curious if others run 40psi or more.

01grand 08-21-2012 01:57 PM

Re: General Grabber AT2 Tire Pressure
You should stick fairly close to the 33psi but a few extra pounds wont hurt. Dont go up to 51psi, thats max for the tire and they will wear fast in the center and ride like a tank. As long as the tread is flat on the pavement you should be ok.

Duff Daddy 08-21-2012 03:27 PM

Re: General Grabber AT2 Tire Pressure
Bump them up a little, depending on load/weight on the tire, 40 will prob be fine. These tires wear well. Good luck.

Dcocch 08-22-2012 10:03 AM

Re: General Grabber AT2 Tire Pressure
I bumped them up to 40psi. The sidewalls straightened out instead of having the "lump" at the bottom. Rides like a far I love these tires!

All times are GMT -5. The time now is 04:39 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community