Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Troubleshooting/Problems (
-   -   P1762 & p1763 (

tedman 11-20-2012 04:34 AM

P1762 & p1763
Good morning, my 2000 grd cherokee laraedo has these codes but no shift or driveability concern's noted. Any ideas ?

Gus9890 11-21-2012 02:10 PM

Re: P1762 & p1763
Welcome to the JG!! Try posting this in the WJ forum so you can be better helped.

Frango100 11-21-2012 05:17 PM

Re: P1762 & p1763
Welcome to the garage.
Presume you have a 4.0 engine with 42RE transmission.
These 2 codes are from the governor pressure sensor and solenoid inside the transmission. Normally they pop up when you really have some shifting problems. Since you don't have them (yet), i think the best is to reset the codes (with a scanner, or just remove the negative battery cable for a minute or so) and see if they come back. If they come back, you probably could better change these 2 components. There could be a line pressure problem and clutches/bands could start slipping without you noticing it now, but it could wear your clutches/bands in a short time. If you ever need to change the governor pressure sensor and solenoid, here is a writeup: 42re, P1762 and P1763, Governor pressure sensor & Solenoid write-up -

tedman 11-24-2012 07:19 PM

Re: P1762 & p1763
Thanks Frank, light went out byitself, if codes return yes i will replace the solenoids, thanks again !!:)

All times are GMT -5. The time now is 05:13 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community