Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Engine Performance/Intakes/Exhausts (
-   -   Corsa exhaust and factory skid plates (

avalys 11-27-2012 05:22 PM

Corsa exhaust and factory skid plates
I have a 2012 Overland V8 with the ORA II package (includes factory skid plates). Will the Corsa exhaust fit without modification?

nlowell 11-27-2012 08:12 PM

Re: Corsa exhaust and factory skid plates
I have a 2011 Overland with Skid Plates. I just installed the Corsa exhuast. I did it by myself in the ORII setting and lets just say its a little challenging to do by yourself :) Theoretically it should fit with no modifications. Mine was sitting slighting to one side (despite my efforts to adjust) which caused a little rattle between the exhaust and the skid plate. I ended up taking it to an exhaust shop where they cut a small piece of my plate off to stop the rattle and also re-welded the rear hangers. The were sitting horizontally with a little too much stress instead of hanging naturally (vertically). 15 minutes later and $30 and all is well. No rattles and the sound is amazing! Exatly what I wanted and a great match to the Volant CAI :D

I'm not sure if there are any major differences between the 2011 and 2012 that would cause a different experience.

avalys 11-29-2012 08:00 PM

Re: Corsa exhaust and factory skid plates
Good enough for me. Just placed the order. Hopefully it will be here next week.

All times are GMT -5. The time now is 09:16 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community