Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Interior/Exterior/Visual (http://www.jeepgarage.org/f182/)
-   -   Removing carpet (http://www.jeepgarage.org/f182/removing-carpet-52794.html)

Jordan's Jeep 01-12-2013 12:19 PM

Removing carpet
 
I searched and couldn't find anything about removing the carpet. Has anyone done it or know of a how to or write up somewhere? Tips and advice needed.

Thanks

05wkguy 01-15-2013 01:22 PM

Re: Removing carpet
 
Haven't done it on the Jeep but the process usually involves removing the seats,remove center console,remove sill plates, start lifting carpet and see what else is in the way.

Anon155 01-16-2013 11:20 PM

Re: Removing carpet
 
I had to remove the carpet part way when I had a leaky sun roof. The process overall is pretty simple. 05wkguy is right. You're gonna have to remove all of the seats with an air wrench, remove the sill plates, and unbolt the side pillars and seat belt bolts. It's best to use a good set of interior pry tools bought from harbor freight or amazon for cheap. The side pillars have a small square piece that pops out near the top of the pillar. There is a set screw behind it that needs to be removed. I almost ruined my pillars by not seeing it at first. I didn't have to remove the center console though, the carpet just slides under it 2 inches or so. Start at the front and work your way back pulling it up on both sides of the center console. Once you get it out from under the center console, it just lifts up from there. The carpet ends just under the rear seat.

Jordan's Jeep 01-17-2013 10:28 AM

Re: Removing carpet
 
Thanks guys

copley2596 01-22-2013 06:21 AM

Re: Removing carpet
 
CARPETS AND FLOOR MATS

REMOVAL

Remove the front seats.
Remove the rear passenger seat cushion.
Remove the floor console.
Remove the park assist module, the final drive control module, and the park assist / final drive control module mounting bracket.
Remove the front door sill scuff plates, Refer to Trim Panel.
Remove the cowl trim panels, refer to Trim Panel.
Remove the rear passenger door sill scuff plates, refer to Trim Panel.
Remove the lower B-pillar trim panels, Refer to Trim panel.
Remove the carpet from the vehicle.

INSTALLATION

Install the carpet in the vehicle.
Install the floor console.
Install the lower B-pillar trim panels.
Install the rear passenger door sill scuff plates.
Install the cowl trim panels.
Install the front door sill scuff plates.
Install the park assist / final drive control module mounting bracket, the park assist module, and the final drive control module.
Install the rear passenger seat cushion.
Install the front seats.


All times are GMT -5. The time now is 10:26 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community