Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Troubleshooting/Problems (http://www.jeepgarage.org/f203/)
-   -   Access to fuel level sensor. (http://www.jeepgarage.org/f203/access-to-fuel-level-sensor-54116.html)

Tony Norton 02-02-2013 06:03 AM

Access to fuel level sensor.
 
Hi All,

Re: 2002 UK registered Grand Cherokee WG 2.7 CRD

I suspect that my PCI drop-out problems may possibly relate to the fuel level sensor or a dodgy connection to same. Reason I suspect this, just prior to the system dropping out the fuel gauge gives an incorrect reading, about a quarter of a tank lower than I know it should be.

Could somebody tell me please how I can get access to the fuel level sensor, which I assume is fitted to the top of the fuel tank. I've had the spare wheel and jack out of the recess in the boot (trunk) but there are no visible removable panels. There are 2 panels that seem to be fitted with adhesive, not screws. It almost begins to look like a classic manufacturer's instruction "Remove front and rear axles, engine and transmission, raise bodywork from chassis to gain access to top of fuel tank....." you know the sort of thing.

Can anyone point me along the right route please?

Thanks in advance.

Tony Norton

Frango100 02-02-2013 06:46 AM

Re: Access to fuel level sensor.
 
You have to drop the tank Tony, to get access to the level sending unit. I donīt know if there is a difference in the tank unit for a gas WG or a diesel, i didnīt download that part of the manual. For the gas version, there is a tank unit with pump and level sensor. A big plastic nut on top of the tank holds the unit in place.
But the diesel engine already has a low pressure pump (next to the high pressure pump) mounted on the engine, so the tank unit could be different.


All times are GMT -5. The time now is 10:38 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community