Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Troubleshooting/Problems (http://www.jeepgarage.org/f203/)
-   -   Start/Electrical problem 2,7 crd (http://www.jeepgarage.org/f203/start-electrical-problem-2-7-crd-54649.html)

JeepThor 02-12-2013 03:25 AM

Start/Electrical problem 2,7 crd
 
Hi

Have a 2002 Jeep Grand Cherokee 2.7 CRD that would not start / no reaction when the ignition key is turned and has zero impact on the lights and instruments that are all dead no - reaction. All fuses checked OK battery has standby voltage of 12.6 volts. The car ran fine when it was parked for 3 days ago. Suspect that previous engine wash possibly may have had an influence or perhaps the ignition key. Any good suggestions for a solution would be appreciated

JMLoughrey 02-12-2013 11:15 AM

Re: Start/Electrical problem 2,7 crd
 
check power at your ignition harness directly. thats where i would start

d.gasnik 03-17-2013 10:32 AM

Re: Start/Electrical problem 2,7 crd
 
How do you check the power to that harness?

Frango100 03-26-2013 07:19 AM

Re: Start/Electrical problem 2,7 crd
 
The problem could be the ignition switch, a battery cable or a bad ground.
To check that the battery cable and/or ground are ok, use a system which is not switched by the ignition switch, such as the power seats. If they work ok, then the main ground and battery feed cable seem to be ok. In that case most probably the ignition switch is faulty or even a main fuse blown. Check in the power distribution center under the hood if the fuses are ok (fuses 14 and 15).


All times are GMT -5. The time now is 02:08 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community