Hi. Installing aftermarket driving lights.
Is there a preference on how to string wires from engine compartment through the firewall and into the jeep?
I ve chosen an accessible spot to install the ON/OFF switch . Where should i pull the wires through to the interior?
(A relay is wired to battery and battery sits on passenger side of vehicle so stringing through that side somehow.)
As always looking forward to your guys' ideas. Thanks.
Re: wiring suggestions?
I think when my dad installed additional lights on my jeep long before I started driving, he reused a hole behind/near the pcm/ecu.
I had to run other wires and drilled my own hole (still need to seal it off the rest of the way). If you drill your own you can buy a rubber grommet from Lowes to prevent the wires from cutting on the metal.
Thanks for advice vonericsen. I will checkout the jeeps pcm /ecu.
|All times are GMT -5. The time now is 06:04 PM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community