Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Trouble Shooting/Problems/Service (http://www.jeepgarage.org/f107/)
-   -   Uconnect, Blind Spot Monitor fail after battery disconnect (http://www.jeepgarage.org/f107/uconnect-blind-spot-monitor-fail-after-battery-disconnect-55372.html)

fourstar 02-24-2013 04:34 PM

Uconnect, Blind Spot Monitor fail after battery disconnect
 
2013 Grand Cherokee Overland, 5.7L, 4WD QTII/QLII.
I unbolted the positive battery cable under the hood to attach a wire to power a remote brake actuator. After replacing the bolt, the radio/nav/backup camera does not come on, and the EVIS says the Blind Spot Monitor is not functioning. Is there some reset procedure to go through after a battery disconnect? I can't locate anything in the OM or elsewhere on this site or the net.

fourstar 02-24-2013 05:57 PM

Re: Uconnect, Blind Spot Monitor fail after battery disconnect
 
After about 30 minutes everything started working again. Unfortunately, not soon enough to keep the dear wife from finding out. :slapfight:


All times are GMT -5. The time now is 06:04 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community