Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Interior/Exterior/Visual (http://www.jeepgarage.org/f182/)
-   -   Led tail light bulbs in an 05 (http://www.jeepgarage.org/f182/led-tail-light-bulbs-in-an-05-a-56946.html)

z3ro0 03-22-2013 12:26 PM

Led tail light bulbs in an 05
 
Wanted to see whose all running led bulbs in the stock housings and how are you guys setting up resistors..

Instead of buying the led tails, I thinking of getting the stockers tinited and running 2 sets of led bulbs..
My question is do I need to run 2 set of resistor a side?? And which wires to plug them into??

I have the pinouts thanks to the Mopar connectors website but stumped at which wires to tap.. I know the obivious ground but which + source to tap..

Here's the pinout: (right side the same minus the trailer signal wires)
1 WT/TN BRAKE LAMP SWITCH OUTPUT
2 RD/DG FUSED B(+)
3 WT/DB TRAILER TOW TURN SIGNAL
4 WT/YL TRAILER TOW TURN SIGNAL
5 WT/VT FUSED PARK LAMP RELAY OUTPUT
6 WT/LG BACKUP LAMP FEED
7 WT/DG LEFT REAR TURN SIGNAL CONTROL
8 BK GROUND

I want to get so feedback before I start blowing fuses :lol:

Anyone done this in there 05-06??

Isaac

robpp 03-22-2013 06:51 PM

6 ohm resistor between the blink and ground wires.

Then you need 2 different leds. On a CK type one regular.

z3ro0 03-22-2013 10:58 PM

Re: Led tail light bulbs in an 05
 
Yea I have 2 6 ohms with the led bulbs..

So jump one between pin 7 + 8 (this one I understand should work), then the other to pin 1 + 8 or pin 5 + 8?

robpp 03-23-2013 12:21 AM

Do it before the plug. You put one end of resistor to the ground and other on the blink wire.

Resistor goes between the 2 wires.

robpp 03-23-2013 12:22 AM

And for each side you need a CK 3157 as well as regular 3157.


All times are GMT -5. The time now is 11:35 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community