Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Engine Performance/Intake/Exhaust (
-   -   4.7 wj no start no run. (

douger0500 03-22-2013 08:46 PM

4.7 wj no start no run.
I bought the jeep not running. Previous owner had issues with wiring to the crankshaft position sensor. I tried running the engine on carb cleaner to and it barely sputters.. p0320 p0725 and a intermittent Idle control valve code. Replaced crank sensor.

Previous owner found out wiggling the plug on the ecm would make the engine run so he replaced the ecm plug. I tested the plug at the crank sensor. 5volt supply is good. Ground has no resistance and I am waiting til tomorrow to test the 24 pin and the feed for the ecm at the crank sensor plug.

I'm guessing there is either an issue with pickup line from ecm to crank poisition sensor. Or damaged Ecm. Any way to test ecm?

Much appreciated, Doug.

Frango100 03-23-2013 12:08 AM

Re: 4.7 wj no start no run.
Welcome to the garage.
I think that only a specialized shop with the right test equipment can test the ECM.

All times are GMT -5. The time now is 05:26 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community