Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Troubleshooting/Problems (
-   -   05 Limited, chrome side door moulding questtion (

SilverLimited 04-25-2013 05:36 PM

05 Limited, chrome side door moulding questtion
The chrome door molding on my 05 Limited's rear door is loose and rattles. All the other doors are fine.

Does anyone know exactly how that piece is attached. I suspect that the clips are a part of the entire molding assembly and just press into the door.

But can the molding be removed without breaking the clips off in the door. I'd like to know this before I attempt to remove it and then figure out a way to secure it again.

BASSO'MATIC 04-27-2013 03:51 PM

Yes. You can remove the molding but it is pretty fragile. I broke a couple clips when I removed mine but used a soldering iron to melt the pieces together. From the factory, those moldings have a thin strip of sealant or something similar which in my case deteriorated over time. I just used some 3m auto trip double sided tape to take care of the rattling issue. Hope this helps and good luck.

Madanio24 05-05-2013 03:10 PM

Re: 05 Limited, chrome side door moulding questtion
If you want to remove it carefully. remove the interior door panel and reach in that way to release the clips. then as stated use some 3m tape.

All times are GMT -5. The time now is 10:16 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community