4 inch lift
Wanting to lift my 06 GC limited 4 inches, will this affect the drive shaft, brake lines or anything else,
Re: 4 inch lift
IF you are looking for something cheaper, the next best option is the OME HD 3" lift (700 from Kolak) stacked using an isolator puck cut down to 1.5" in the rear and a couple of 1/4" strut plates on top in the front. No more than 2 though, they net you about 1/2" of lift a piece. That would net you the highest results without causing front end damage. You don't want to run higher than 23" hub to fender measurements with this lift. Some have had to learn that the hard way...I have it on my 05. I'm using only 1 strut plate and measure 22" in the front with the HEMI and all my armor. You can fit a 33" (285/70r17) tire with some trimming to the pinch welds. I haven't had a problem with this setup in the 8 months it's been on. I love the ride, some say it's a bit harsh, but I love it compared to stock. Since my lift is stacked, I had to trim the rear gas tank skid, install longer sway bar links, and a adjustable rear track bar. All bought from Rusty's offroad. I did not however need to extend my brake lines as of yet. I will need to make some brackets when I decide to switch out my rear shocks for something a tad longer.
Sorry for the long post, hope that helps :thumbsup:
|All times are GMT -5. The time now is 12:37 AM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community