Retrofit of headlight wasers to ARB bar on '10 Overland
I decided to finally fit my headlight washers to my ARB bar.
Very simple task. I drew the cutout for left & right using the holes on the plastic bumper. I traced the outline to a piece of light plastic, then cut them out so I had 2 templates. I then taped the bar off, & drew the outline of the required holes, after selecting the best mounting position on the bar. I didn't want to hit anything inside the bar.
I drilled the holes for my rounded corners using, holesaws & drill bits (1x25mm, 2x16mm,& 3x10mm). I then cut between these with a jigsaw to enlarge the hole. A little filing to remove the sharp edges & some paint to avoid rust in the future. The mounting assembly worked first time, both left & right hand sides.
this is the near finnished product.
Re: Retrofit of headlight wasers to ARB bar on '10 Overland
cool. Very nice mod!
|All times are GMT -5. The time now is 07:50 AM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community