Electronic Throttle Control circuit
Hey everyone I have been having a few issues with my jeep lately. I had an ETC issue pop up which caused my jeep to stall and no start. I had it towed to my dealer and they said the cps sensor needed to be replaced they replaced that along with a map sensor. The cps fixed the no start but they said that replacing the map sensor didn't fix another issue that they were seeing and that I needed a new PCM, but they said that I could still drive the Jeep since I wasn't experiencing any other issues. So my wife and I take a trip covering about 800 miles on the last leg of the trip I received the dreaded light again, and I guess the Jeep kicked into limp mode, but we were able to make it home. I cycled the key as per the manual and it cleared, so I thought awesome I'm good to go. Drive the Jeep maybe a mile or so no issues. Start the jeep again, driving and the light comes back on. Thinking it may be my swirl motor going out I perform the resistor mode, just stuck the 4.7k ohm resistor in the plug and wrapped it with electrical tape, took it for a test drive no issues. Then the next drive, it randomly came on again. This issue seems to be intermittent at best.
Sent from my SAMSUNG-SGH-I747 using Tapatalk now Free
|All times are GMT -5. The time now is 05:09 PM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community