Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Suspension/Driveline/Brakes/Wheels/Tires (
-   -   TPMS can't recalibrate after new tyres (

grandcrd 10-16-2013 10:32 PM

TPMS can't recalibrate after new tyres
Hi Guys, put new OEM, kumo tyres on my 2012 GC Ltd after 42K. now the monitor system tells me the tyre pressure is down and one sensor is missing. have run the car, several times, for 25 minutes @ over 25KM but failed to recalibrate. dealer has tried new sensors and new tyres & rims, reboot the PCU, but all to no avail. Any Ideas???. thanks Tom.

ColdCase 10-17-2013 08:32 AM

Re: TPMS can't recalibrate after new tyres
Perhaps one of vehicle sensor receivers is damaged, but their scan tool should have picked that up? When you move tires around, does the missing sensor fault move too, or is it always the same corner.

They tried OEM sensors right and the TPMS sensors tested OK on their portable TPMS scanner right?

grandcrd 10-17-2013 07:36 PM

Re: TPMS can't recalibrate after new tyres
Hi ColdCase. no the sensors stay the same when u change tyres or put new sensors in. it registers as there is no sensor or pressure on the front driver's side(right side here in Aust).
hopefully the dealer has a TPMS scanner. will ask him as I have to take it back in next week for this fault & stalling @ start up fault.

ColdCase 10-21-2013 05:28 PM

Re: TPMS can't recalibrate after new tyres
Sounds like a bad receiver or connection on that corner.

All times are GMT -5. The time now is 04:45 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community