Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Troubleshooting/Problems (http://www.jeepgarage.org/f203/)
-   -   transmission pressure switch (http://www.jeepgarage.org/f203/transmission-pressure-switch-68381.html)

99limitedgc 11-25-2013 06:56 AM

transmission pressure switch
 
Anybody familer on how to remove the plastic conncetor for the trans pressure switch. transmission is being rebuilt but I broke the switch when removing the trans. there has to be a trick I would like to learn it!:confused:

Frango100 11-25-2013 07:40 AM

Re: transmission pressure switch
 
You are talking about the 5-45RFE transmission? Did you break the line pressure sensor, which sits on the right aft side?
This sensor is mounted with one bolt, just remove the bolt and pull out the (rest of the) sensor. The connector is just the squeeze type, squeeze it and pull.

99limitedgc 11-26-2013 12:22 AM

Re: transmission pressure switch
 
yes that is the sensor. must not be holding my mouth right. It was very dirty down there so I must not have removed all the dirt and stuff under the plastic tab. It did break when removing the trans. Thanks for the response!

Frango100 11-26-2013 07:06 AM

Re: transmission pressure switch
 
New line pressure sensor can be found here (besides speed sensors and solenoid block): www.electricaladvantage.net

99limitedgc 12-04-2013 12:49 AM

Re: transmission pressure switch
 
Thanks for the info! Found the lock was broken and very dirty. cleaned connector and was able to move the plastic lock far enough to remove the broken sensor and install on the new one.


All times are GMT -5. The time now is 09:48 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community