Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (
-   Tech Tips DIY/How To (
-   -   Tips for Undercoating (

KSomes 12-08-2013 07:10 PM

Tips for Undercoating
Hello all,

As everyone knows, Winter has come upon us. For everyone who is affected by the dreaded salt, I have a few questions. I am looking to do another undercoating job to my WK, but I did this recently to the rear half during the Summer. I noticed that in the places that were rusting quite a bit, the rust cam through the undercoating even though I removed most and covered what little was left with a rust reformer and primer. I expected it to come back, but not within a few months. So, I thought I would ask for some advice!

First, is there a technique to this to allow a more complete and effective job? Also, does anyone have a recommendation as to get the hard to reach areas of the front portion of the under body? Lastly, should I worry about removing any excess old undercoat, or should I paint right over that?

I have really been procrastinating with this, so hopefully some advice serves as motivation! All help is greatly appreciated!

xJoshxx 12-08-2013 07:21 PM

Re: Tips for Undercoating
You could line-x the entire underneath.

I've seen that done it's expensive due to the amount of time it takes to prep everything.


or Eastwood - Auto Body Repair Tools | MIG Welder | TIG Welder | Plasma Cutter | Auto Body Supplies & Accessories has alot of rust protection

JMY85 12-11-2013 08:29 PM

Chassis saver paint

KSomes 12-13-2013 11:50 AM

Re: Tips for Undercoating
Thanks for the advice, I think I will be using Por 15 or Chassis Saver.

All times are GMT -5. The time now is 06:36 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community