Jeep Garage  - Jeep Forum

Jeep Garage - Jeep Forum (http://www.jeepgarage.org/forums.php)
-   Grand Cherokee - WK (http://www.jeepgarage.org/f5/)
-   -   When you pull out... (http://www.jeepgarage.org/f5/when-you-pull-out-9739.html)

1 GRAND 05-24-2010 12:34 PM

When you pull out...
 
When you pull out from a dead stop and tromp the gas, does your WK spin the front tires before all the tires kick in? I thought the Jeep sent more torque split to the rear tires. My ZJ and WJ would always bark the rear tires on hard acceleration, not the front tires.

Mike_Levy 05-24-2010 12:45 PM

Re: When you pull out...
 
It sends most of the torque to the rear, the fronts should never spin without the rears spinning too.

I can get all 4 spinning pretty good, or just the rears for a second or so, but never just the fronts.

Scottina06 05-24-2010 12:46 PM

Re: When you pull out...
 
he has the QD2 with front elsd

LTrainGC 05-24-2010 01:12 PM

Re: When you pull out...
 
QDII has a 48/52 torque split. When stock I would get a little chirp from the fronts if I pegged it from a stop.

Scottina06 05-24-2010 01:23 PM

Re: When you pull out...
 
If I really get on my Jeep I have major spin on all four tires....QT2. Highly modified engine though

Mike_Levy 05-24-2010 01:45 PM

Re: When you pull out...
 
I dunno which Quadra-whatever I have. Its the NV146 Transfer Case though, with a 10/90 split during normal driving, according to some magazine article. ;)

Scottina06 05-24-2010 01:47 PM

Re: When you pull out...
 
qt1

LTrainGC 05-24-2010 02:24 PM

Re: When you pull out...
 
The NV140 (found with QTI) and the NV245 (found with QTII and QDII) both have a 48/52 F/R torque split, all the time.

The NV146 (found with the SRT8) has a variable torque split - I'm not sure if it can vary all the way from 0/100 to 100/0, but it does transfer torque to the axle with more traction.

Jeffjs7 05-24-2010 03:54 PM

Re: When you pull out...
 
I thought Jeep says the QDII system can route 100% power to any one wheel? I've read this all over the web.

LTrainGC 05-24-2010 04:04 PM

Re: When you pull out...
 
Quote:

Originally Posted by Jeffjs7 (Post 212633)
I thought Jeep says the QDII system can route 100% power to any one wheel? I've read this all over the web.

Haha you're right... here is how Jeep explains it:

QDII:
http://www.jeep.com/en/4x4/how_syste...uadra_drive_2/

QTII:
http://www.jeep.com/en/4x4/how_syste...quadra_trac_2/

QTI:
http://www.jeep.com/en/4x4/how_syste...k/quadra_trac/

Note about QTI: The Grand Cherokee SRT8 uses the Quadra-Trac on-demand system that drives the rear driveshaft and engages the front driveshaft when needed, either when slip is sensed, or with throttle anticipation, which engages the front prior to slip when throttle is applied.

BJB 05-24-2010 04:05 PM

Re: When you pull out...
 
There is one more thing with the SRT transfer case. From a key cycle, the vehicle has to go faster then 22.5 mph to perform some actuator motor / clutch pack test. After that the front should grab quicker. At least that is my understanding...

555ctsv 05-24-2010 04:39 PM

Re: When you pull out...
 
I just get a chirp, but i guess i have bigger tires. I really think a tune would do me good though. Anything below 2000rpms feels kinda weak to me. Guess im going to email them about the tune again... I've only had the engine back since December, think its broken in yet? lol


All times are GMT -5. The time now is 02:26 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community