Go Back   Jeep Garage - Jeep Forum > Search Forums

Join Jeep Garage Today
Showing results 1 to 30 of 30
Search took 0.01 seconds.
Search: Posts Made By: Doug4230
Forum: Grand Cherokee - ZJ 09-17-2014, 08:02 AM
Replies: 1
Views: 57
Posted By Doug4230
Transfer case slop and noise

98 Jeep Grand Cherokee Larado 6cyl. 294000 miles. Took a long road trip with no real problems. On return, first time I tried to use 4wd got loud banging and jerking. I can rotate the front driveshaft...
Forum: Grand Cherokee - ZJ 10-04-2013, 04:20 PM
Replies: 0
Views: 354
Posted By Doug4230
Radio speaker separation issues

Anyone have experience fixing speaker separation with this factory radio? There is a "joystick" toggle to select which speakers get power. I only get full output from the front tweeters and partial...
Forum: Grand Cherokee - ZJ 09-29-2013, 08:39 AM
Replies: 4
Views: 489
Posted By Doug4230
Re: Towing w/4 wheels on the ground

Thanks for the input!:)
Forum: Grand Cherokee - ZJ 09-27-2013, 07:41 AM
Replies: 4
Views: 489
Posted By Doug4230
Towing w/4 wheels on the ground

Anyone know if a 98 Jeep Grand Cherokee 6cyl Selectrac can be towed with all wheels on the ground? My 99 Quadratrac is towable in "park" w/the transfer case in "nutral". The Selectrac owners manual...
Forum: Troubleshooting/Problems 09-19-2013, 04:49 PM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

I should add that, yes, the security symbol indicates as it should and goes out. I checked my door frame bus wireing (earlier post) and it came back clean. At this point really thinking either...
Forum: Troubleshooting/Problems 09-19-2013, 04:40 PM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

I think we both may be missing the obvious here. If the Jeep jumped time or broke the timing chain (unlikely as it failed with a miss then no restart, not a lockdown), would it likely not show the...
Forum: Troubleshooting/Problems 09-17-2013, 04:37 PM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

Yes, checked all three wires for short to ground or each other. Harness seems clean. Wondered about internal mechanical failure as well. Not having a lift, it is going to be tough to visualize the...
Forum: Troubleshooting/Problems 09-17-2013, 11:28 AM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

Tried new crank sensor. No luck. Same no start condition, still throws a cam position sensor fault. Going to try another cam sensor in the off chance that the first one was bad out of the box. Don't...
Forum: Troubleshooting/Problems 09-17-2013, 07:17 AM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

Good tip. I will see if it is registering.
****Cranking engine does NOT indicate anything on the tach gauge. Guess I will pull the starter and install a new crank sensor this morning.
Forum: Troubleshooting/Problems 09-16-2013, 02:35 PM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

Wires from the PCM check out OK. Still getting JUST the cam sensor fault. Thinking about trying another sensor just in case it was bad out of the box (stranger things have happened). What might be my...
Forum: Troubleshooting/Problems 09-15-2013, 12:44 PM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

Thanks, I will be back on it this afternoon.
Forum: Troubleshooting/Problems 09-15-2013, 08:34 AM
Replies: 7
Views: 733
Posted By Doug4230
Re: 99 Grand Cherokee Limited drivers door harness

I would still like to locate a wire harness to replace the damaged one. With the amount of repairs needed I would feel better just replacing it! Anyone know a part number or source???
Forum: Troubleshooting/Problems 09-15-2013, 06:34 AM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

What pin corresponds to the CPS return wire? Battery is fully charged and cranks starter as it should. Engine sounds to me as if it is not hitting in proper time which would seem to validate code...
Forum: Troubleshooting/Problems 09-14-2013, 04:45 PM
Replies: 17
Views: 1,395
Posted By Doug4230
Re: No start condition. Cam Position Sensor indicated.

Is the PCM connector in the engine compartment, passenger side, next to the firewall? I cannot get it apart to check if that is the correct connection. Removed red lock tab and tried everything but...
Forum: Troubleshooting/Problems 09-14-2013, 04:35 PM
Replies: 14
Views: 2,608
Posted By Doug4230
Re: WJ Cylinder 4 misfire mystery.

That kind of warranty response deserves praise. Few companies understand the importance of standing behind a product anymore. Who was it, I might be looking for an engine very soon.
Forum: Troubleshooting/Problems 09-14-2013, 01:30 PM
Replies: 17
Views: 1,395
Posted By Doug4230
No start condition. Cam Position Sensor indicated.

1999 Jeep Grand Cherokee Limited. 4.7 v8. 240000 miles+. Jeep started missing towing a light trailer up a grade, engine was heating but not to redline. Stopped and shut off then could not get a...
Forum: Troubleshooting/Problems 09-14-2013, 01:20 PM
Replies: 7
Views: 733
Posted By Doug4230
Re: 99 Grand Cherokee Limited drivers door harness

I have had odd lights and gauge behavior in the past. Right now doorlocks, windows and door chime seem to be ok. Unit consistently resets the Camshaft Position Sensor fault. I have 5v at the...
Forum: Troubleshooting/Problems 09-14-2013, 12:25 PM
Replies: 7
Views: 733
Posted By Doug4230
Re: 99 Grand Cherokee Limited drivers door harness

That makes sense, if I can just figure out the D#### connector release. Second problem, just had the Jeep fail with a Cam Position Sensor fault. Replaced the unit and no change. I read somewhere that...
Forum: Troubleshooting/Problems 09-11-2013, 06:07 PM
Replies: 7
Views: 733
Posted By Doug4230
Re: 99 Grand Cherokee Limited drivers door harness

At least 4 wires are partly to completely broken. Two with failed insulation and visible breaks, one completely separated, and another couple suspect with evident crimps and "soft" wires in the...
Forum: Troubleshooting/Problems 09-11-2013, 04:39 PM
Replies: 7
Views: 733
Posted By Doug4230
99 Grand Cherokee Limited drivers door harness

I need to locate a replacement wire harness for the drivers door connection to the body. There is more than one damaged or broken wires and I now have interior lights always on, door locks not...
Forum: Troubleshooting/Problems 04-05-2013, 01:45 PM
Replies: 2
Views: 1,055
Posted By Doug4230
Trouble Codes

My 99 Jeep 4.7 Grand Cherokee is showing codes - P0420 and P1195. These are defined as "cataylst sys. efficiency below threshold bank 1" and "oxygen sensor heater circuit is bad".
Anone have advice...
Forum: Grand Cherokee - WJ 10-22-2012, 05:56 PM
Replies: 2
Views: 855
Posted By Doug4230
Thermostat Bolt size

REALLY BAD DAY. Went to change the oil sending unit as part of some other work including a front driveshaft CV replacement and a chemical fix (I hope) for a head gasket leak.
Oil sender body sheared...
Forum: Troubleshooting/Problems 10-05-2012, 04:17 PM
Replies: 2
Views: 533
Posted By Doug4230
Driveshaft question

99 Grand Cherokee front driveshaft CV joints are totally failing (constant noise, slack). I need the vehical but do not have the parts on hand to fix it. I have heard both ways on removing the shaft...
Forum: Troubleshooting/Problems 08-19-2012, 08:11 AM
Replies: 13
Views: 5,585
Posted By Doug4230
Re: Climate Control problems

The blend doors failed on my 99 Limited. Did not affect WHERE the air went, just weather or not it had any heat when it got there. Spent a winter freezing since the drivers side only blew cold. Does...
Forum: Troubleshooting/Problems 08-18-2012, 09:04 AM
Replies: 9
Views: 3,321
Posted By Doug4230
Re: 99 Grand Cherokee oil pressure

Used Sea Foam on last oil change, planned to do that again as well.
Vehicle has 200k plus miles and seems to develop problems faster than I can fix them. Cannot afford to pay a shop for the kind of...
Forum: Troubleshooting/Problems 08-18-2012, 08:00 AM
Replies: 9
Views: 3,321
Posted By Doug4230
Re: 99 Grand Cherokee oil pressure

Yeah, that is my first plan. It was changed out once already in the past two years however. I have read that some aftermarket units do not perform as well as the OEM units, anyone have a comment on...
Forum: Troubleshooting/Problems 08-17-2012, 04:37 PM
Replies: 9
Views: 3,321
Posted By Doug4230
Re: 99 Grand Cherokee oil pressure

Was one quart low, pressure returned at driving rpm after adding to full but is still reading low at idle.
Forum: Troubleshooting/Problems 08-17-2012, 04:29 PM
Replies: 13
Views: 7,190
Posted By Doug4230
Re: 2000 jeep grand cherokee no oil pressure when warm

Did you ever solve your problem? I have similar issues.
Forum: Troubleshooting/Problems 08-17-2012, 04:11 PM
Replies: 9
Views: 3,321
Posted By Doug4230
99 Grand Cherokee oil pressure

Just lost oil pressure with no warning. Pressure went to zero, check guages light came on. Engine was one quart low, added oil and cured issue for the drive home, however pressure drops low 10-20 psi...
Forum: Troubleshooting/Problems 04-21-2012, 10:42 AM
Replies: 2
Views: 1,145
Posted By Doug4230
Tracking down "clicking" noise

My 99 Grand Cherokee has had loud "clicking" noise and "binding" in tight turns (especially reverse) for quite a while. I assumed front CV joints failing but had not gotten around to repair yet. Now...
Showing results 1 to 30 of 30

 
Forum Jump

All times are GMT -5. The time now is 10:14 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community