Go Back   Jeep Garage - Jeep Forum > Search Forums

Join Jeep Garage Today
Showing results 1 to 19 of 19
Search took 0.01 seconds.
Search: Posts Made By: sxr951
Forum: Grand Cherokee - WJ 12-16-2015, 10:21 PM
Replies: 2
Views: 748
Posted By sxr951
pcm remove silicone.resolder chips

Wj..2004 overland...bad pcm code.butbmy wj is still running....I've seen that guy on u 2ube..says its the solder that's so thin it cracks..so how to remove silicone 2 gwt 2 the chips?
Any kind of...
Forum: Troubleshooting/Problems 12-16-2015, 10:03 PM
Replies: 10
Views: 512
Posted By sxr951
Re: 04 wj ac clutch wrx by jump only

PCM which makes the ground for the compressor clutch relay, so the problem can be there.[/FONT][/QUOTE]
10-4...ill xplore more and I'm getting a transducer from a junk yard 2 c
.what do u think...
Forum: Troubleshooting/Problems 12-16-2015, 08:32 PM
Replies: 10
Views: 512
Posted By sxr951
Re: 04 wj ac clutch wrx by jump only

http://imagizer.imageshack.us/v2/150x100q90/633/Bww3Qq.png (http://imageshack.com/f/hlBww3Qqp)
Forum: Grand Cherokee - WK 12-16-2015, 06:15 PM
Replies: 11
Views: 1,584
Posted By sxr951
Re: 4.7 Rough Idle Mystery Continues

I gotta try the disco sensors ..but I have a bad pcm code.but still reads codes..this pcm is from an 02..my original is my 04 and won't read ny codes
Forum: Troubleshooting/Problems 12-16-2015, 04:25 PM
Replies: 10
Views: 512
Posted By sxr951
Re: 04 wj ac clutch wrx by jump only

I got it!!!!!! U were right on post 6.. I found the values from another thread.hooked a AA battery to the signal wire and my clutch powered up!!!!! Thx for the schematics!! Was checking every where!
Forum: Troubleshooting/Problems 12-16-2015, 03:32 PM
Replies: 18
Views: 16,367
Posted By sxr951
Re: A/C Clutch Cycle Switch Location?

Great thread! I just followed your processaas my clutch stopped also on my 04 overland...but I had zero volts on the sensor engine running but did have 5v on the hot..so I hooked up a AA batt to the...
Forum: Troubleshooting/Problems 12-16-2015, 12:44 PM
Replies: 10
Views: 512
Posted By sxr951
Re: 04 wj ac clutch wrx by jump only

I got power on one side of relay but the ground side doesn't ground!..85 and 86
Forum: Troubleshooting/Problems 12-15-2015, 10:30 PM
Replies: 10
Views: 512
Posted By sxr951
Re: 04 wj ac clutch wrx by jump only

ImageShack - 2015-12-15-17-08-09.png (http://imageshack.com/i/hlBww3Qqp)
X is the tranducer? Same line as arrow
Forum: Troubleshooting/Problems 12-15-2015, 07:41 PM
Replies: 10
Views: 512
Posted By sxr951
Re: 04 wj ac clutch wrx by jump only

Wow great ! Thx now I can trace from pcm out...
Would u have the wire colors from ac modulator in dash (on off switch) to pcm?..the ac light goes on..thx!!!!!
Forum: Troubleshooting/Problems 12-15-2015, 03:05 PM
Replies: 10
Views: 512
Posted By sxr951
Exclamation 04 wj ac clutch wrx by jump only

Hello folks..ac light goes on and tried diff modualtor thinking may b the switch.
.if I jump relay then clutch goes on. I think the low press switch is near radiator..3 wires..
But which.wires...
Forum: Engine Performance/Intake/Exhaust 11-17-2014, 04:37 PM
Replies: 10
Views: 8,708
Posted By sxr951
Re: 2003 4.7L to 4.7L HO Conversion

Salutations fellow greese monkeys! :) .I have almost same situaton. My 2004 overland valve dropped .piston is in pieces got bent c rod. Got hole in cylinder from piston pin jammin. Anyway...i need a...
Forum: Tech Tips/DIY/How to 11-17-2014, 02:44 PM
Replies: 2
Views: 2,061
Posted By sxr951
Re: use non ho 4.7 block on 04 wj ho 4.7?

I'd sure like 2 c the 2 blocks side by side. And would engine moint bolts fit from a dodge and I think pistond r the same just has domes to.increase compression
Forum: Tech Tips/DIY/How to 11-17-2014, 01:09 PM
Replies: 2
Views: 2,061
Posted By sxr951
Talking use non ho 4.7 block on 04 wj ho 4.7?

Salutations greese monkeys! ;).. ok here's wut..I got my 04 wj ho apart and crankshaft in my kitchen.. my #8 crank bent jammin the floating piston rod thru the cyl wall.pistons in pieces of course.....
Forum: Grand Cherokee - WK2 - 03-17-2012, 11:09 PM
Replies: 6
Views: 2,526
Posted By sxr951
Exclamation Re: Is there a setting to turn off the chime when the door is open?

ok i got it done. lookie here you amateurs.! lol

but when i restarted jeep with 2 doors open it wouldn't idle.had to keep foot on the gas. had to shut doors so computer would re calibrate all...
Forum: Troubleshooting/Problems 03-15-2012, 09:16 PM
Replies: 5
Views: 2,303
Posted By sxr951
Re: water in driverside floor under carpet

just fixed mine.. antenna wire rubber grommet fell out. when it rains it just pours rt in.
Forum: Tech Tips/DIY/How to 02-24-2012, 01:37 AM
Replies: 8
Views: 2,815
Posted By sxr951
Re: Patching up a 4.7L engine oil pan

did that chip save you any gas mileage?
Forum: Engine Performance/Intake/Exhaust 12-15-2011, 04:48 AM
Replies: 22
Views: 17,680
Posted By sxr951
Forum: Engine Performance/Intake/Exhaust 12-15-2011, 04:39 AM
Replies: 22
Views: 17,680
Posted By sxr951
Thumbs up Re: Oil Pan Replace

2004, WJ, overland ,,4.7 HO...welp! i did it. what a biitch it was.. separating the windage tray was not easy. Box cutter did nothing, The gasket was to hard from age .need a putty knife and tap it...
Forum: Engine Performance/Intake/Exhaust 12-04-2011, 08:17 PM
Replies: 22
Views: 17,680
Posted By sxr951
Re: Oil Pan Replace

we will see. doing all this rt now on a 04 .4.7. so far i cant get the oil pan off . ill try the box cutter thing in morning
Showing results 1 to 19 of 19

 
Forum Jump

All times are GMT -5. The time now is 06:07 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community

JeepGarage.org is in no way associated with or endorsed by FCA US LLC. Chrysler, Dodge, Jeep, Ram, Mopar and SRT are registered trademarks of FCA US LLC.