Go Back   Jeep Garage - Jeep Forum > Search Forums

Join Jeep Garage Today
Showing results 1 to 40 of 43
Search took 0.01 seconds.
Search: Posts Made By: garllo
Forum: Grand Cherokee - WK 03-11-2015, 03:55 PM
Replies: 5
Views: 531
Posted By garllo
Re: New Transmission for our Jeeps

Kinda like talking to the service adviser at the dealership!:lol:
Forum: Engine Performance/Intake/Exhaust 01-20-2015, 04:07 PM
Replies: 8
Views: 917
Posted By garllo
Re: Why do I see oil below the oil filter location?

I had the same problem and checked all of the possibilities and it turned out to be a front seal leak. The oil would get hurled at the filter then drip into the troth beneath the oil filter. New seal...
Forum: Troubleshooting/Problems 11-13-2014, 06:14 PM
Replies: 1
Views: 311
Posted By garllo
Re: Thumping noise

Tuned out to be the e- brake hardware.
Forum: Troubleshooting/Problems 11-11-2014, 07:51 PM
Replies: 1
Views: 311
Posted By garllo
Thumping noise

I'm getting a "thumping noise" when applying light pressure on the brake pedal. Seems to be coming from the rear. This just started and at first it would appear only when coasting around 40mph. If I...
Forum: Grand Cherokee - WK 11-01-2014, 04:21 PM
Replies: 12
Views: 1,090
Posted By garllo
Re: Head lights on 2008 laerado

Silverstars or any other brand of high performance headlight do make a difference. I run Silverstar in my fog lights also.
Forum: Grand Cherokee - WK 10-31-2014, 03:03 PM
Replies: 393
Views: 36,336
Posted By garllo
Forum: Grand Cherokee - WK 10-31-2014, 02:00 PM
Replies: 1
Views: 312
Posted By garllo
A/C Heat Recirculate Question

Hello All,
Haven't been around for a while but I'm back. I know that there are many posts related to this subject however; My A/C -heat recirculate is not working. The funny thing is that it...
Forum: Troubleshooting/Problems 07-16-2014, 05:38 PM
Replies: 24
Views: 1,950
Posted By garllo
Re: a/c recirculator

Doesn't have dual zone. Only half of the display lighting burnt out (on the dial that selects recalculate). Did seem to stop working at the same time.
Forum: Troubleshooting/Problems 07-15-2014, 08:44 PM
Replies: 24
Views: 1,950
Posted By garllo
Re: a/c recirculator

Mine seemed to stop working when the lights on the heater / a/c control burned out. They actually burned out over the "recirculated" section on the dial?
Forum: Grand Cherokee - WK 02-11-2014, 03:11 PM
Replies: 3
Views: 612
Posted By garllo
Re: Part numbers for replacement parts on both ends of the front driveshaft?

Had a similar problem with mine 2 years ago and the dealer replaced the front shaft under the lifetime powertrane warranty
Forum: Suspension/Brakes/Wheels/Tires 02-11-2014, 02:58 PM
Replies: 6
Views: 737
Posted By garllo
Re: Coil Springs

Monroe makes what they call a "quick strut" (rock auto) It's a strut ,coil spring and new strut mount in one assembly.
Forum: Troubleshooting/Problems 02-06-2014, 01:22 PM
Replies: 7
Views: 1,154
Posted By garllo
Re: water pump replacement

Thanks very much!
Forum: Troubleshooting/Problems 02-05-2014, 10:13 AM
Replies: 7
Views: 1,154
Posted By garllo
Re: water pump replacement

Do you know what the torque spec is for the water pump bolts and the bolts on the thermostat housing?
Forum: Troubleshooting/Problems 12-25-2013, 10:02 AM
Replies: 5
Views: 385
Posted By garllo
Re: Factory exhaust

I had a magnaflow system on my last Corvette. They make a quality product.
Forum: Troubleshooting/Problems 12-24-2013, 08:26 AM
Replies: 5
Views: 385
Posted By garllo
Re: Factory exhaust

Thank you! The dealer checked the exhaust system the other day when it went in for service. They said that it was tight with no leaks so that's my only concern. I have around 67k on the jeep now and...
Forum: Troubleshooting/Problems 12-18-2013, 11:36 AM
Replies: 5
Views: 385
Posted By garllo
Factory exhaust

I have a question. Is the factory exhaust system on the 3.7 stainless steel? Mine seems to have gotten louder but seems to be a resonance only. Upon acceleration it's not noisy. Anyone have any...
Forum: Engine Performance/Intake/Exhaust 10-09-2013, 10:24 AM
Replies: 9
Views: 580
Posted By garllo
Re: 3.7 compatibility

Best of luck on your upcoming deployment and Thank You!!
Forum: Grand Cherokee - WK 09-10-2013, 09:16 AM
Replies: 4
Views: 988
Posted By garllo
Re: WK grey floor mats

Buy the Weathertech floor liners. I live in New England and the floorliners keep snow and mud from getting into the carpets. Great product. FloorLiner DigitalFit Product Education Center |...
Forum: Grand Cherokee - WK 09-02-2013, 08:34 AM
Replies: 393
Views: 36,336
Posted By garllo
Forum: Engine Performance/Intake/Exhaust 05-12-2013, 12:14 PM
Replies: 119
Views: 11,038
Posted By garllo
Re: Rep your oil and filter!

I have been using a conventional oil in the GC and change it regularly. As for Mobil1 , I've used it in my Corvette ( factory filled w/ Mobil 1) for 10 years without any burnoff and it's subjected...
Forum: Troubleshooting/Problems 05-31-2012, 12:27 PM
Replies: 9
Views: 5,477
Posted By garllo
Re: Limp mode

Another cause could be the notorious shift bezel assembly. Very common problem and the jeep will act as yours has. Search the forum and you will gain alot of info on this. There is also a pretty good...
Forum: Troubleshooting/Problems 05-19-2012, 08:35 AM
Replies: 7
Views: 1,046
Posted By garllo
Re: PRNDL position switch

That's what I was hoping for! Thanks everyone
Forum: Troubleshooting/Problems 05-18-2012, 01:53 PM
Replies: 7
Views: 1,046
Posted By garllo
Re: PRNDL position switch

Actually I think I answered my own question. I reading that again it says "front wheel drive" so I'm thinking that it's for another model. If I were young again I would have seen that the first time...
Forum: Troubleshooting/Problems 05-18-2012, 01:44 PM
Replies: 7
Views: 1,046
Posted By garllo
PRNDL position switch

Just a question and I'm not sure if I am posting in the proper place but here goes; In looking over the Lifetime powertrain warranty for my 2007 WK I noticed that they cover the "PRNDL position...
Forum: Troubleshooting/Problems 03-09-2012, 11:09 AM
Replies: 2
Views: 740
Posted By garllo
Re: Hey boys,have a look at this...tell me what u think!

Looks better than pulling the entire dash!
Forum: Technical Tips/DIY/How-To 03-06-2012, 03:27 PM
Replies: 5
Views: 4,459
Posted By garllo
Re: DIY WK 2005-2010 3.7L Spark Plug Details

I replaced mine last year with a platinum instead of the factory copper core plug.
Forum: Troubleshooting/Problems 02-20-2012, 01:26 PM
Replies: 8
Views: 1,251
Posted By garllo
Re: vibration around 65mph

Dealer replaced the front driveshaft. Seems okay now!
Forum: Troubleshooting/Problems 02-03-2012, 01:34 PM
Replies: 32
Views: 3,121
Posted By garllo
Re: What do u guys do for all these damn rattles!!!??

I had a similar rattle in the same area shortly after I bought it. The dealer found that it was the cover for the air bag on the passengers side and they said that they insulated it with foam. I...
Forum: Troubleshooting/Problems 02-03-2012, 01:24 PM
Replies: 8
Views: 1,251
Posted By garllo
Re: vibration around 65mph

Will post the results!
Forum: Troubleshooting/Problems 02-02-2012, 10:06 AM
Replies: 8
Views: 1,251
Posted By garllo
Re: vibration around 65mph

Doesn't "slam" at all. The dealer says that the front drive shaft is the culprit
and they will be replacing it next week.
Forum: Troubleshooting/Problems 01-29-2012, 09:29 PM
Replies: 8
Views: 1,251
Posted By garllo
Re: vibration around 65mph

I also think that this is a likely problem. We'll see what the dealer comes up with!
Forum: Troubleshooting/Problems 01-27-2012, 02:45 PM
Replies: 4
Views: 602
Posted By garllo
Re: Help?

When I bought my Jeep the cabin air filter was a dealer installed option.As usual , they wanted much more than what I considered a fair price so I purchased the parts online and installed the housing...
Forum: Troubleshooting/Problems 01-27-2012, 02:13 PM
Replies: 8
Views: 1,251
Posted By garllo
vibration around 65mph

Hi All,
I have noticed lately that around 65mph I am getting a vibration and it seems to intensify with speed. Acts very much like a bad universal joint.If you let off on the power it...
Forum: Troubleshooting/Problems 01-06-2012, 02:58 PM
Replies: 5
Views: 798
Posted By garllo
Re: Fog Light Help

Dealer showed me how to turn them on when I took delivery otherwise I think that I would have spent some time hunting!
Forum: Tech Tips DIY/How To 12-13-2011, 04:47 PM
Replies: 12
Views: 1,791
Posted By garllo
Re: Oil change light

You should be able to set the interval at either 3K or 6K
Forum: Troubleshooting/Problems 12-13-2011, 04:30 PM
Replies: 9
Views: 3,486
Posted By garllo
Re: 2005 Laredo 4.7 hesitates-stalls-shakes

I would also check to see if there are any codes active or in history!
Forum: Troubleshooting/Problems 11-08-2011, 11:42 AM
Replies: 17
Views: 1,211
Posted By garllo
Re: dealership broke my jeep

I hate dealers service !! Several times when I had my oil changed I had to tighten a loose oil filter.
Forum: Troubleshooting/Problems 10-06-2011, 01:53 PM
Replies: 6
Views: 1,268
Posted By garllo
Re: Shifter Bezel issue

Thank you gents for your help!!
Forum: Troubleshooting/Problems 10-03-2011, 12:53 PM
Replies: 6
Views: 1,268
Posted By garllo
Re: Shifter Bezel issue

No LO - Full time 4WD. Once you pull that out is the board (the area to clean) exposed?
Forum: Troubleshooting/Problems 10-03-2011, 12:39 PM
Replies: 6
Views: 1,268
Posted By garllo
Re: Shifter Bezel issue

How difficult is it to get to the circuit board?
Showing results 1 to 40 of 43

 
Forum Jump

All times are GMT -5. The time now is 07:54 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community

JeepGarage.org is in no way associated with or endorsed by FCA US LLC. Chrysler, Dodge, Jeep, Ram, Mopar and SRT are registered trademarks of FCA US LLC.