Go Back   Jeep Garage - Jeep Forum > Search Forums

Join Jeep Garage Today
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Search: Posts Made By: Ben_02WJ
Forum: Troubleshooting/Problems 01-03-2013, 12:19 PM
Replies: 10
Views: 987
Posted By Ben_02WJ
Re: 2000 Laredo w 182,000 miles losing antifreeze

I just had to replace my heater core. Like you I was loosing small amounts of antifreeze as seen in the reservoir. I did not get any sweet smell in the cab or wet carpet. I finally decided to do...
Forum: Troubleshooting/Problems 10-09-2012, 12:31 PM
Replies: 23
Views: 2,905
Posted By Ben_02WJ
Re: Any early WJ's have bad door seals?

Last weekend I was detailing my Jeep and decided to try to fix my door seal issue. I bought the 3M Weatherstrip Adhesive but in the end did not use it. By the time I was ready to tackle the problem...
Forum: Grand Cherokee - WJ 09-10-2012, 05:12 PM
Replies: 16
Views: 1,438
Posted By Ben_02WJ
Re: HO exhaust question

My 2002 HO has all three cats...
Forum: Troubleshooting/Problems 09-05-2012, 08:57 AM
Replies: 3
Views: 1,086
Posted By Ben_02WJ
Re: 04 Grand Cherokee Dying, HELP!

I agree with the crankshaft position sensor. However, I would also look into the throttle body. My ZJ with the 5.2 V8 exhibited similar symptoms and it ended up being a filthy throttle body. A $4...
Forum: Grand Cherokee - WJ 09-05-2012, 08:51 AM
Replies: 455
Views: 42,118
Posted By Ben_02WJ
Re: post your pictures of your wj

Here is a pic of my 2002 Overland

https://lh5.googleusercontent.com/-w-AiK_-rDbE/UEdYjRZs4kI/AAAAAAAAAdc/_Ic9DQcPWbE/w684-h513-p-k/august%2B037.JPG
Forum: Troubleshooting/Problems 07-25-2012, 01:58 PM
Replies: 3
Views: 3,564
Posted By Ben_02WJ
Re: Anyone Know how to remove wiper arms?

Here is what I have in the manual:

REMOVAL
1. Lift the front wiper arm to its over-center position to hold the wiper blade off of the glass and relieve the spring tension on the wiper arm to...
Forum: Troubleshooting/Problems 07-13-2012, 10:43 PM
Replies: 9
Views: 3,624
Posted By Ben_02WJ
Sounds like a plan :beer:

Sounds like a plan :beer:
Forum: Troubleshooting/Problems 07-13-2012, 02:16 PM
Replies: 9
Views: 3,624
Posted By Ben_02WJ
Re: 4.7 HO rebuilt, need ground locations

I crawled under my Jeep and took a picture of where it looks like that wire is going. I would need a second person to "jiggle" the wire or not be wearing my good cloths (a little muddy under there...
Forum: Troubleshooting/Problems 07-13-2012, 08:24 AM
Replies: 9
Views: 3,624
Posted By Ben_02WJ
Re: 4.7 HO rebuilt, need ground locations

I went out and looked at my '02 and it looks like it goes down to the bottom of the block, but since I am at work right now I can't crawl under it to verify exactly where it goes. My guess is you...
Forum: Troubleshooting/Problems 07-12-2012, 07:16 AM
Replies: 11
Views: 1,679
Posted By Ben_02WJ
Re: Really need some help with Balljoint installation issue

Just to double check... Looking at the description for the ball joints at NAPAonline; the upper balljoint does not articulate but only spins and the lower is a standard ball joint. You installed...
Forum: Troubleshooting/Problems 07-09-2012, 10:40 AM
Replies: 11
Views: 1,679
Posted By Ben_02WJ
Re: Really need some help with Balljoint installation issue

Here is the assembly instructions from the service manual:

INSTALLATION
1. Position the steering knuckle on the ball studs.
2. Install and tighten the bottom retaining nut to 109 Nm (80 ft....
Forum: Troubleshooting/Problems 07-09-2012, 10:01 AM
Replies: 11
Views: 1,679
Posted By Ben_02WJ
Re: Really need some help with Balljoint installation issue

I have found this issue when using cheap ball joints that have a polymer (plastic) bearing surface. Usually I can get them to seat enough to stop the turning using a hammer (not on the stud but the...
Forum: Engine Performance/Intake/Exhaust 07-08-2012, 09:31 AM
Replies: 5
Views: 1,966
Posted By Ben_02WJ
Re: 3" Exhaust Install

So, I am a noob and after some looking around I found that many people recommend Kolak... Where can I view this vendors products and prices?

Thanks!
Showing results 1 to 13 of 13

 
Forum Jump

All times are GMT -5. The time now is 06:43 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community

JeepGarage.org is in no way associated with or endorsed by Chrysler Group LLC.