Go Back   Jeep Garage - Jeep Forum > Search Forums

Join Jeep Garage Today
Showing results 1 to 14 of 14
Search took 0.01 seconds.
Search: Posts Made By: Ehron
Forum: Troubleshooting/Problems 06-28-2013, 02:18 PM
Replies: 17
Views: 973
Posted By Ehron
Re: Milky Transmisison Fluid -- 05 5.7

The service bulletin I found was the for 3.7. $1800 for a used transmission with 40k miles, drained, new filters, new dipstick seal, etc.
Forum: Troubleshooting/Problems 06-28-2013, 10:36 AM
Replies: 17
Views: 973
Posted By Ehron
Re: Milky Transmisison Fluid -- 05 5.7

Update: AC line was building condensation, running down the line, and pooling around the dipstick tube on top of the transmission. So, freaking rubber seal around the dipstick tube cost us $1800. ...
Forum: Troubleshooting/Problems 06-25-2013, 10:16 PM
Replies: 17
Views: 973
Posted By Ehron
Re: Milky Transmisison Fluid -- 05 5.7

I have to admit I didn't understand what was meant by "unload the Jeep." Thanks to the comments of anyoldiron I now understand. I couldn't sell it to someone in this condition without telling them.
Forum: Troubleshooting/Problems 06-25-2013, 12:56 PM
Replies: 17
Views: 973
Posted By Ehron
Re: Milky Transmisison Fluid -- 05 5.7

I stopped by a local Jeep mechanic this morning to talk about it. He also suggested perhaps someone put the wrong kind of fluid into the transmission. Quoted me $1500-$1800 to install a junk yard...
Forum: Troubleshooting/Problems 06-25-2013, 07:37 AM
Replies: 17
Views: 973
Posted By Ehron
Re: Milky Transmisison Fluid -- 05 5.7

The transmission cooler in our WK is built into the A/C condenser, not the radiator. Could A/C refrigerant leak into the transmission through the cooler.

I'm not sure how I would check for leaks...
Forum: Troubleshooting/Problems 06-24-2013, 08:09 PM
Replies: 17
Views: 973
Posted By Ehron
Milky Transmisison Fluid -- 05 5.7

We're having shifting problems in our 05 5.7 equipped WK. Checked the fluid today, and to my horror, the dipstick is covered in milky, pink fluid. It doesn't smell like ATF.

My initial searching...
Forum: Troubleshooting/Problems 06-24-2013, 08:01 PM
Replies: 6
Views: 2,431
Posted By Ehron
Re: 05 WK Radiator Replacement?

I couldn't get the lines broken on the power steering pump or the hydraulic fan. I ended up having to remove the fan, lines, and power steering pump as a unit. I'm not sure if that is required to...
Forum: Troubleshooting/Problems 06-19-2013, 03:31 PM
Replies: 1
Views: 455
Posted By Ehron
Re: NGC to engine ground strap location

I'm thinking I may have to go look at a local Jeep for sale to get this figured out...
Forum: Troubleshooting/Problems 06-17-2013, 12:38 PM
Replies: 12
Views: 911
Posted By Ehron
Re: '08 WK Hemi poor/low idle

Is there any pattern you can identify? Does it only stall when you're using A/C, or when it's hot outside, or only during warm-up, etc?
Forum: Troubleshooting/Problems 06-17-2013, 11:38 AM
Replies: 1
Views: 455
Posted By Ehron
NGC to engine ground strap location

I replaced the engine (5.7) in my wife's 05 WK a few months ago. Sadly, when all was complete I had an extra ground strap left over. The part number and description (Figure 8-1215 from parts manual):...
Forum: Troubleshooting/Problems 12-09-2012, 03:48 PM
Replies: 6
Views: 357
Posted By Ehron
Re: Installing Reman -- Help with hole/tube in block

Ahh. Thanks JohnGreen. Living in the south I'm not sure I've ever seen one. I suspect my old engine had a plug over that hole or something. I'll look into it. Thanks.
Forum: Troubleshooting/Problems 12-09-2012, 08:41 AM
Replies: 6
Views: 357
Posted By Ehron
Re: Installing Reman -- Help with hole/tube in block

Yeah, I didn't think it was right, but it was an exact fit...

Can someone with a 5.7 please look at their block and tell me if that's a sensor, tube, or something else entirely? I'd greatly...
Forum: Troubleshooting/Problems 12-08-2012, 10:18 PM
Replies: 6
Views: 357
Posted By Ehron
Re: Installing Reman -- Help with hole/tube in block

Ok, tube I had stuck in there was for the EGR to intake manifold. Doh. So, anyone know what that hole is for in the back of the block? THe one right above the exhaust manifold?
Forum: Troubleshooting/Problems 12-08-2012, 02:06 PM
Replies: 6
Views: 357
Posted By Ehron
Installing Reman -- Help with hole/tube in block

Hello all. I'm installing a re-manufactured engine into my wife's 05 5.7 WK. It's been a slow process... Consequently I've forgotten what goes in one of the holes in the block.

I have a tube...
Showing results 1 to 14 of 14

 
Forum Jump

All times are GMT -5. The time now is 04:56 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community

JeepGarage.org is in no way associated with or endorsed by Chrysler Group LLC.