Go Back   Jeep Garage - Jeep Forum > Search Forums

Join Jeep Garage Today
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Search: Posts Made By: 99WJ
Forum: Troubleshooting/Problems Discussion 04-26-2011, 04:02 PM
Replies: 28
Views: 7,035
Posted By 99WJ
Re: Sticking Caliper

SO, you re-used your glazed pads? Did you remove the glaze/burnt layer first? Again if you only changed the pads on one side and not the other they are at different wear points and the side with the...
Forum: Troubleshooting/Problems Discussion 04-18-2011, 12:48 PM
Replies: 28
Views: 7,035
Posted By 99WJ
Re: Sticking Caliper

you have teves on your rear wheels...
Forum: Troubleshooting/Problems Discussion 04-17-2011, 10:36 PM
Replies: 28
Views: 7,035
Posted By 99WJ
Re: Sticking Caliper

Oh and while you're in the area inspect your axle boots, the rubber bit covering the axle shaft between the end of its tube and the actual hub, they like to rip or otherwise detach and let the grease...
Forum: Troubleshooting/Problems Discussion 04-17-2011, 10:26 PM
Replies: 28
Views: 7,035
Posted By 99WJ
Re: Sticking Caliper

Perhaps you overheated and warped that rotor so bad it is out of spec and rubbing against the pads when you aren't applying the brake... but this is only if you didn't change the rotor with the...
Forum: Wheels/Tires/Brakes 04-01-2011, 01:28 PM
Replies: 12
Views: 9,902
Posted By 99WJ
Re: Bleeding your brakes

Nope my local steelership wanted $100 to plug one in and just cycle the ABS pump, so I found a parking lot with some gravel and re-bled later that day and again about a week or so later. Pretty sure...
Forum: Wheels/Tires/Brakes 04-01-2011, 12:23 PM
Replies: 12
Views: 9,902
Posted By 99WJ
Re: Bleeding your brakes

It's actually pretty simple, I can bleed all 4 of mine in about a beer or two, usually around an hour. Gravity bleeding works well but I usually don't have the time for it; I use a small hand powered...
Forum: Troubleshooting/Problems 04-01-2011, 04:26 AM
Replies: 6
Views: 1,175
Posted By 99WJ
Re: Cant Pass Inspection

Unplugging the battery should clear the code until the computer has enough data to figure out the problem is still there. Did you try to see what the code was with the key on-off sequence trick? It...
Forum: Wheels/Tires/Brakes 03-31-2011, 11:59 PM
Replies: 12
Views: 9,902
Posted By 99WJ
Re: Bleeding your brakes

The scan tool cycles or primes the abs control pump. It usually won't get air in it unless you really have a lot of air in the lines and when it does the ABS light will come on the dashboard. A...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -5. The time now is 09:08 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community

JeepGarage.org is in no way associated with or endorsed by Chrysler Group LLC.