Jeep Garage  - Jeep Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Had new 6cyl motor installed in Nov 2012 . After getting it back check engine light flashed and power loss..shut off ignition and restart and drives fine...went back to garrage and they replaced plugs said it was a miss fire...picked up jeep and this happened again..took it back and they said code 35 miss fire and they replaced power pack ...picked up and this happened again..took back and they said shows injector 3 .. They did a engine flush and again it happened ..I'm at a loss.. Motor they say has 40'000 miles on it.. Any ideas ?
 
1 - 1 of 1 Posts
Top