Jeep Garage  - Jeep Forum banner
1 - 4 of 4 Posts

· Registered
2004 GC Special Ed
Joined
·
6,908 Posts
Discussion Starter · #1 · (Edited)
Last year my door lock actuators were acting up upfront and doors wouldn't unlock as they should. I replaced em with some from the JY. Now a few times I've noticed my drivers side door won't lock. Would it be the actuator again? Or possibly one of the rods? The lock won't slide over. But I can hear a click from within. Also tried key in door and no dice, wont turn. I haven't pulled the door panel off yet. That's in my plans for tomorrow. Just not liking the idea of it not locking.
Thanks in advance
Jason.
 

· Registered
2004 GC Special Ed
Joined
·
6,908 Posts
Discussion Starter · #2 ·
Whoops meant to put in troubleshooting section if a mod can move please. Don't think I am able to from the forum app.
 

· Registered
2004 GC Special Ed
Joined
·
6,908 Posts
Discussion Starter · #3 ·
Figured it out. Actuator needs to be replaced. Part that the slide lock piece attached to rusted and barely moving.
 

· Registered
2004 GC Special Ed
Joined
·
6,908 Posts
Discussion Starter · #4 ·
got an actuator from JY yesterday and all is good now
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top