Jeep Garage  - Jeep Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Is it possible to wire aftermarket fog lights {PIAA 2100} into the existing factory fog light wiring harness so they are controlled by the original factory switch for the existing fog lights? Is there enough voltage etc. to run them at the same time as the original ones without any issues.

I've installed fog/driving lights as the instructions state many times before but thought this might be easier and more practical if possible.

Thanks, my Jeep is a 2004 GC.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top