Jeep Garage  - Jeep Forum banner
1 - 2 of 2 Posts

·
Registered
JGC Limited
Joined
·
175 Posts
Discussion Starter · #1 · (Edited)
I finally painted and attached the ARB bullbar to the jeep about a month ago which also required a new grille as I did not want to cut the old grille in case the repairs made on the bullbar were way off (front rght hand damage).
Happily the bullbar was only a 1/2 inch out on the repaired side and it came together looking good.
I had 2 attempts at re jigging the grille and ended up using the chrome surround off the 2004/5 grill and added 1mm stainless mesh to get the result below.

So what I have left is the remains of the 1st attempt being 1mm stainless mesh and high tensile hex head nuts and bolts.

I am happy to give away if anyone is interested, plus postage.

Can either send whole or just send mesh section.
 

Attachments

·
Premium Member
Joined
·
1,087 Posts
Nice! That thing looks awesome and love the grille!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top