[simmo32]

Hi all
I'm still in the middle of it, but developing a quadra lift over ride kit, so that you can have extra pre set heights.
This is as low as I have got it so far, 25ish mm from tyre to guard. Will soon hopefully have guard tuck tyre soon, just a little more refining to do.

Cheers
Ben

 

[simmo32]

Will do, have hit a bit of a snag. I can get the front to goto approx 25mm gap but rear wont move. I think it might have something to do with the air tank / reservoir being full.
Has anyone got any schematics on the air system or any detailed information?

 

[simmo32]

This is the lowest I can get at present. Approx 20mm gap in front and 60mm in rear. It is like this as the bottom sill is level / flat.

 

[simmo32]

Can't post how I did it. But kits will be available for sale once finalised


Cheers

 

[simmo32]

The modification will allow you to lower the vehicle passed park mode. I am still finalising the heights as the lowest I can get at the moment is 25mm in front and 70mm on rear from tyre to guard. I want to even this out more if I can.
Once finalised ill have it setup so that you can drive at the height also (at your own risk), it will be a very firm ride.

 

[simmo32]

That I already have setup. Ill take a picture and load it up tomorrow.
I have 3 settings so far-
Extreme low (still developing)
Super sport (approx 20mm lower than sport mode)
Or1+ (basically or1 but can drive at any speed)

Cheers
Ben

 

[simmo32]

That can be done. But you would still get 3 settings in the kit.
I'm thinking the 3 settings might be
Extra extra low

Sport low (slightly lower than sport mode (even the rear also)

And OR1 - drivable at any speed (at own risk)


Cheers ben

 

[simmo32]

What size tyres do you have. I have now got falken wildpeak a/t 275/55/20 and on the extra extra low mode. The guard just covers the tyre. The switch has 3 positions so you will just not use that mode.
Here's a pic of mine in extra extra low

Cheers

 

[simmo32]

It is still in development. Should have final parameters that I'm happy with in the next 2 weeks. I can have or2 setup so that you can drive on it, I could even test and see how much higher it will go before you get suspension fault then bring it back a little. I wouldn't recommend driving on anything higher than or2 though.
I might setup or2 also as I like driving at that height with the tyres I have now.
Next project is making some rock sliders

 

[simmo32]

At extra extra low it is a very firm ride

 

[simmo32]

Sorry all, busy on other project at the moment. Hopefully have something real soon

 

[simmo32]

Slowly, should have something in the new year. CANBUS system had been doing my head in a little

 

[simmo32]

Yes a little has been going on. Just doing final tweaks at the moment for ride heights at each corner.
The full height mode has need brought down a little also as it didn't leave a lot suspension travel

Cheers


Sent from my iPhone using JeepGarage