Jeep Garage  - Jeep Forum banner
1 - 3 of 3 Posts

·
Registered
2010 Jeep Grand Cher
Joined
·
2 Posts
Discussion Starter · #1 ·
We have a 2010 JGC, sometimes when we start it the engine is missing and rattling like crazy. We then turn it off, wait a bit and start it again, runs fine. It has done this maybe 5 or 6 time in the past three years. Today it did this about 6 times in a row before it run fine. Has anyone else had this problem with their 3.7L V-6??????
:confused:
 

·
Registered
Joined
·
2,070 Posts
We have a 2010 JGC, sometimes when we start it the engine is missing and rattling like crazy. We then turn it off, wait a bit and start it again, runs fine. It has done this maybe 5 or 6 time in the past three years. Today it did this about 6 times in a row before it run fine. Has anyone else had this problem with their 3.7L V-6??????
:confused:
Hi papajohn398,
We regret to hear you've been experiencing these concerns with your vehicle. We understand that at this time you are just reaching out to other forum members for advice. However, if you do choose to visit a dealer to have this addressed, we would be more than happy to offer an additional layer of assistance. Please feel free to send us a PM if this is something you are interested in.
Julie
Jeep Social Care Specialist
 

·
Registered
Joined
·
1,338 Posts
It will have codes stored, so that is your first move and just go to any auto parts store..and they will put a code reader on it for no charge. Avoid the Jeep dealer at all cost, as they will charge you $120 just to read codes. It sounds like something simple, like a $20 crank position sensor which takes 5 minutes to replace.
 
1 - 3 of 3 Posts
Top