[REDDIZE]

Does anyone have photos of the location that a floor jack/hydraulic hoist should be positioned under? The jacking point described in the manual - body flange behind front tire - in from arrow; is not compatible with anything other than the supplied screw jack.

I'm thinking just inwards on the frame; where 4 robotic weld points can be seen is the place to be?

 

[PECo]

You need a jack pad designed for pinch welds. Amazon is a good source for a cheap one. A hockey puck run over a table saw would work, too. In a pinch, I’ve also used a small block of scrap wood run over a table saw.

 

[grandoverland]

I'm guessing that after 7 years he's pretty much figured it out by now....😉

 

[PECo]

Oops! Sorry about that.

 

[jimntempe]

Oops! Sorry about that.

most of us have done that at one time or another