[Shift.91]

Ok so I know it's been done but I continue to be having problems. I've changed only the front park/turn signals to a white LED, and installed a resistor in line on the turn signal circuit and yet I still have a fast flashing issue. I tried installing another resistor on the rear with the incandescent bulb and it just caused my rear signal to not work at all. WTF!?

 

[Shift.91]

Anyone at all??

 

[LionheartUK]

Hi Shift, load Resistors should be installed in paralell (accross) the LED bulb, these "simulate" the bulbs element fooling the relay.

Regards

Richard

 

[CNY_WK2]

Not sure if one is available, but you can replace the relay for turn signals with a higher resistance one to eliminate the hyper flash with LED bulbs.

I did this on my Subaru and I know there are ones available for other vehicles too.

Not sure of how many blades are on the Jeep turn signal relay or how they are wired but I would have to bet Xenondepot could easily source one

 

[Shift.91]

I have installed resistors and still have not changed the fast flash.

I could try a new flasher. I'll look into that. Thanks!