Jeep Garage  - Jeep Forum banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Hello all,
I recently purchased a 2004 GC Overland with 70K miles. It has a few issues to deal with such as rear rattles when going over a bumpy road, and door seals needing replaced. Everything else is pretty good.
Anybody have any secrets as to how to remove the rear upper control V-arm to replace the bushings? I'll be trying to do this in my garage with floor stands and a floor jack. Can it be done?
Short Circuit
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.