Jeep Garage  - Jeep Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,178 Posts
Vehicles Equipped With Keyless Enter-N-Go
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the ON/
RUN position (Do not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pressing the brake pedal, push the ENGINE
START/STOP button once to return the ignition to the
OFF/LOCK position.

Vehicles Not Equipped With Keyless Enter-N-Go
1. Turn the ignition switch to the ON/RUN position (Do
not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.

NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
 

·
Registered
Joined
·
1,178 Posts
The OP said he did search. That was my point, it would be easier to look in the manual than search. Especially when in the end you ask someone else to look it up for you. ;)

I got a little Kindle Paper White and loaded the three latest manuals on it. As new updates come out I'll have them ... in the console. For $119 I think it's a cheap accessory. Plus, I loaded the book I'm reading onto it. So tomorrow while I'm waiting for the fish to show up I'll have something to read. :)



.
Well that was a good point indeed. Unfortunately, it went right over my head. :eek:

I've always kept my manuals on the laptop. Good idea loading them on the kindle.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top