Vinyl roof
1 - 20 of 22 Posts
Cool. ..we need to start the black roof club!
Hahah yea we do. But I did it alittle different than yours. I didn't go on to the wing above the rear window. I may add it at some point but for now it's still DCR wing
Well I got it done for free because me and my buddy who installed it needs to custom metal cutting done so we are swapping services. It was a good hook up. The antenna was an absolute pain in the ars!!!!!!! Atleast for us it was
Joined
·
270 Posts
Post up picsagreed, I'm getting mine done today
the more the merrier
yes we do!
Tom we should start a black roof club and the first to have SRT domes for the key fob!!! Hahah just saying
Haha send me an SRT cut out for the garage
Hahaha PM sent
Did you do the gloss black or flat black on the roof? I kinda like my white shark fin, thought about doing a strip over it and leaving the sides white but just seems like such a pita so left it. Did you have to use 3 separate pieces on it?
Gloss black and I cut around the shark fun. Alittle bit of a pain in the ass but it was worth it
The 14's sharkfin can't be removed without dropping the interior headliner
Joined
·
521 Posts
Wondered about that
When we did mine we were able to pull the clips down enough to looses the clip and bolts on the shark fin. Not a fun job but certainly doable and makes it a whole lot easier
Joined
·
364 Posts
is this something someone can do themselves or best left to the pros?
Joined
·
2,183 Posts
After a lot research, I feel like you can do it yourself however you will need some helping hands on the project. The sheer size of vinyl is what makes this difficult.
I've asked a couple times what guys are paying for this not sure what the answer is. The materials are under $200 for the top 3m stuff though...
I'm going to try my luck with the trim first then do the roof if I feel comfortable.
Cut around the shark fin! As Scott said I wasn't dropping the headliner
1 - 20 of 22 Posts
