Jeep Garage  - Jeep Forum banner
1 - 11 of 11 Posts

·
Premium Member
2017 Summit
Joined
·
8,869 Posts
Discussion Starter · #1 ·
I had been posting these surprises in the uConnect upgrade forum, but I don't think the upgrade can be responsible.

Every few days I use the Go Home command, just to make sure the nav is working. Two things were a little different today.

First, whenever I turned onto a new road, the next turn would flash in the instrument cluster for a couple of seconds no matter how far away I was from that turn. It would then show it again when I was within a quarter mile, like it always had. This is pretty cool since I usually have the main screen turned off.

Second, for the first time since I've gotten the car, it found my house, right to the driveway. Up until now it always tried to direct me to a house on the other side of the development.

I lock my garage at night, so I don't know how the gremlins are getting to my Jeep. But, they aren't hurting anything. :)


.
 

·
Premium Member
Joined
·
3,465 Posts
I lock my garage at night, so I don't know how the gremlins are getting to my Jeep. But, they aren't hurting anything. :)
3g?
 

·
Premium Member
2017 Summit
Joined
·
8,869 Posts
Discussion Starter · #4 ·
I like that it flashes the next turn. :)

I'm gonna miss it when it goes away. :(


:lol:


.
 

·
Registered
Joined
·
32 Posts
Is it only the 8.4AN that flashes the turns in the dash? My 8.4A doesn't do that unless there is a setting that I'm missing.
 

·
Premium Member
2017 Summit
Joined
·
8,869 Posts
Discussion Starter · #6 ·
Is it only the 8.4AN that flashes the turns in the dash? My 8.4A doesn't do that unless there is a setting that I'm missing.
I don't think it is supposed to on either. It is something that started of mine out of the blue. I have to use the nav next time out to see if it is still doing it.

On the 8.4an it does show the turn in the cluster when you are about 1/4 mile out. That is selectable in the EVIC.



.
 

·
Registered
Joined
·
32 Posts
No, it doesn't show the turn on the cluster, I've seen a screenshot of it doing it, but haven't figured out how to get mine to do it.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top