I'm stuck while trying to remove the rear prop shaft. Until I get this solved the JGC is a paper weight. Any help to this is appreciated.
According to the workshop manual:
I have removed all the bolts, but am unable to separate the shaft flange from the transmission flange. I can't even tell where it is suppose to separate.
Attached is a photo of the problem flanges before the bolts were all removed.
![Image]()
According to the workshop manual:
- Remove the center support bearing bracket (1). DONE
- Remove propeller shaft from axle pinion flange. DONE
- Remove propeller shaft from transmission/transfer case flange. NOT DONE.
I have removed all the bolts, but am unable to separate the shaft flange from the transmission flange. I can't even tell where it is suppose to separate.
Attached is a photo of the problem flanges before the bolts were all removed.
